This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


7000 series shifter question
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
SilverShoes View Drop Down
Silver Level
Silver Level


Joined: 20 Feb 2014
Location: Seneca, Kansas
Points: 224 		Post Options Post Options   Thanks (0) Thanks(0)   Quote SilverShoes Quote  Post ReplyReply Direct Link To This Post Topic: 7000 series shifter question
    Posted: 11 Aug 2026 at 2:01pm
Have a 7045 with the push pull console cable for the gear selection and I really like the simplicity of the gearshift in the red belly tractors. I have a salvage 7030. My question is will the gearshift fit into my 7045 out of the 7030. Has this been done and will the floor pan switch also or does it have to be fabricated to fit into the black belly tractors
Back to Top
Sponsored Links


Back to Top
DrAllis View Drop Down
Orange Level Access
Orange Level Access


Joined: 12 Sep 2009
Points: 23482 		Post Options Post Options   Thanks (0) Thanks(0)   Quote DrAllis Quote  Post ReplyReply Direct Link To This Post Posted: 11 Aug 2026 at 9:06pm
Should work fine. Use 7030 floor plate.
Back to Top
SilverShoes View Drop Down
Silver Level
Silver Level


Joined: 20 Feb 2014
Location: Seneca, Kansas
Points: 224 		Post Options Post Options   Thanks (0) Thanks(0)   Quote SilverShoes Quote  Post ReplyReply Direct Link To This Post Posted: 12 Aug 2026 at 7:09am
Thanks Doc, not sure if I’m going to do it quite yet. Might just replace the cable until I get everything removed from the other tractor. I just needed a piece of mind before I jumped into it. Too many things on the agenda. Do you have any advice for putting that shift cable in the correct location under the cab. I’m not so sure it was in there right because it was rammed up against the floor plate go through hole and rubbed a gash in the cable. Just seems like a mess of a way to put it in. I had to cut it the cable to even remove it
Back to Top
DrAllis View Drop Down
Orange Level Access
Orange Level Access


Joined: 12 Sep 2009
Points: 23482 		Post Options Post Options   Thanks (0) Thanks(0)   Quote DrAllis Quote  Post ReplyReply Direct Link To This Post Posted: 12 Aug 2026 at 7:20am
Everything is pretty tight and you cannot get rough installing the new one or it won't work right. After 50 years, I'm sure the rubber cab mounts have settled some and 1/4" is a lot. Make the hole oversize if you have to. Have to work from inside the cab and up above the batteries to get it done.
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.043 seconds.


Help Support the
Unofficial Allis Forum