7000 series shifter question
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=211955
Printed Date: 17 Sep 2026 at 4:38pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: 7000 series shifter question
Posted By: SilverShoes
Subject: 7000 series shifter question
Date Posted: 11 Aug 2026 at 2:01pm
|
Have a 7045 with the push pull console cable for the gear selection and I really like the simplicity of the gearshift in the red belly tractors. I have a salvage 7030. My question is will the gearshift fit into my 7045 out of the 7030. Has this been done and will the floor pan switch also or does it have to be fabricated to fit into the black belly tractors
|
Replies:
Posted By: DrAllis
Date Posted: 11 Aug 2026 at 9:06pm
|
Should work fine. Use 7030 floor plate.
|
Posted By: SilverShoes
Date Posted: 12 Aug 2026 at 7:09am
|
Thanks Doc, not sure if I’m going to do it quite yet. Might just replace the cable until I get everything removed from the other tractor. I just needed a piece of mind before I jumped into it. Too many things on the agenda. Do you have any advice for putting that shift cable in the correct location under the cab. I’m not so sure it was in there right because it was rammed up against the floor plate go through hole and rubbed a gash in the cable. Just seems like a mess of a way to put it in. I had to cut it the cable to even remove it
|
Posted By: DrAllis
Date Posted: 12 Aug 2026 at 7:20am
|
Everything is pretty tight and you cannot get rough installing the new one or it won't work right. After 50 years, I'm sure the rubber cab mounts have settled some and 1/4" is a lot. Make the hole oversize if you have to. Have to work from inside the cab and up above the batteries to get it done.
|
|