This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


180 floods when tank is full
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
chuck linn View Drop Down
Silver Level
Silver Level


Joined: 13 Dec 2012
Location: ky
Points: 78 		Post Options Post Options   Thanks (0) Thanks(0)   Quote chuck linn Quote  Post ReplyReply Direct Link To This Post Topic: 180 floods when tank is full
    Posted: 02 Jul 2015 at 6:59pm
180 gas will flood when tank is full or near full as tank gets closer to empty runs and starts normal is the needle sticking or something else wrong thanks for looking
Back to Top
Sponsored Links


Back to Top
Clay View Drop Down
Orange Level
Orange Level
Avatar

Joined: 11 Sep 2009
Location: Udall, Kansas
Points: 9893 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Clay Quote  Post ReplyReply Direct Link To This Post Posted: 02 Jul 2015 at 8:30pm
Needle and seat may need replaced.  What is the condition of the float?
Back to Top
8050/8030/185 View Drop Down
Silver Level
Silver Level


Joined: 08 Sep 2014
Location: United States
Points: 171 		Post Options Post Options   Thanks (0) Thanks(0)   Quote 8050/8030/185 Quote  Post ReplyReply Direct Link To This Post Posted: 02 Jul 2015 at 9:09pm
Definitely a needle and seat  and float problem. Pull the carb and give it an overhaul. Make sure you have a brass float. Depending on what the needle is made out of Gasohol will affect the operation too.
Back to Top
MACK View Drop Down
Orange Level
Orange Level


Joined: 17 Nov 2009
Points: 7664 		Post Options Post Options   Thanks (0) Thanks(0)   Quote MACK Quote  Post ReplyReply Direct Link To This Post Posted: 02 Jul 2015 at 10:03pm
Make sure the new needle has a rubber tip.    MACK
Back to Top
PaulB View Drop Down
Orange Level
Orange Level


Joined: 12 Sep 2009
Location: Rocky Ridge Md
Points: 5107 		Post Options Post Options   Thanks (0) Thanks(0)   Quote PaulB Quote  Post ReplyReply Direct Link To This Post Posted: 02 Jul 2015 at 11:10pm
Before you go into the Carburetor check the vent in the gas cap. Just run it slightly loose. Just might be an easy fix.
If it was fun to pull in LOW gear, I could have a John Deere.
Real pullers don't have speed limits.
If you can't make it GO... make it SHINY
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.069 seconds.


Help Support the
Unofficial Allis Forum