190 xt series III questions

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   Looking to trade for a 190 xt
I have one already so a little familiar with them
The one I'm looking at fired right up after sitting for a couple months.
It was fairly cold out as well 38 or so
The tractor had to warm up for 10 minutes before the hydraulics would work, after that they worked great
Any ideas
Also he had tied the drain plugs together for a equalizer tube, I'm assuming the seal between two resistors has gone bad
Any idea on repairing the seal, time it takes cost etc
Thanks for any advice

	This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
	The Forum	Parts and Services	Unofficial Allis Store	Tractor Shows	Serial Numbers	History

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
rudyk Members Profile Send Private Message Find Members Posts Add to Buddy List Bronze Level Joined: 20 Apr 2016 Location: camdenton,mo Points: 151	Post Options Post Reply Quote rudyk Report Post Thanks(0) Quote Reply Topic: 190 xt series III questions Posted: 30 Nov 2016 at 7:41pm
	Looking to trade for a 190 xt I have one already so a little familiar with them The one I'm looking at fired right up after sitting for a couple months. It was fairly cold out as well 38 or so The tractor had to warm up for 10 minutes before the hydraulics would work, after that they worked great Any ideas Also he had tied the drain plugs together for a equalizer tube, I'm assuming the seal between two resistors has gone bad Any idea on repairing the seal, time it takes cost etc Thanks for any advice

Sponsored Links

MACK Members Profile Send Private Message Find Members Posts Add to Buddy List Orange Level Joined: 17 Nov 2009 Points: 7664	Post Options Post Reply Quote MACK Report Post Thanks(0) Quote Reply Posted: 30 Nov 2016 at 9:41pm
	Check all connections between sump and hydraulic and replace front seal in hydraulic pump. If the two oil compartments are tied togather, it needs split and replace seals. May also need the housing the PD slides into replaced. MACK