This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


190XT Gas governor spring
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
DaveCinIN View Drop Down
Orange Level
Orange Level


Joined: 12 Sep 2009
Location: Kouts, IN
Points: 629 		Post Options Post Options   Thanks (0) Thanks(0)   Quote DaveCinIN Quote  Post ReplyReply Direct Link To This Post Topic: 190XT Gas governor spring
    Posted: 20 Jul 2012 at 11:16pm
I think I need a governor spring for my 190XT gas. If I adjust the high idle according to the book, the low idle is too high (won't go to the stop on the carb). If I set it so it will go to low idle, then it will only rev to 2000 rpm. Called SLI and AGCO replaced the spring assembly (2 Parts) with 3 seperate parts and they are very proud of them. They now have an auxillary spring. Anyway I need a good spring if anyone has one. 
Back to Top
Sponsored Links


Back to Top
DrAllis View Drop Down
Orange Level Access
Orange Level Access


Joined: 12 Sep 2009
Points: 21905 		Post Options Post Options   Thanks (0) Thanks(0)   Quote DrAllis Quote  Post ReplyReply Direct Link To This Post Posted: 21 Jul 2012 at 5:21pm
 If you have to, you can drill a new hole on the governor arm up 1/2" or so (from the original hole) to reach your high idle specs. It will require reworking the throttle cable anchor bracket just a bit to allow for a straight line, but that can be done easily.
Back to Top
DaveCinIN View Drop Down
Orange Level
Orange Level


Joined: 12 Sep 2009
Location: Kouts, IN
Points: 629 		Post Options Post Options   Thanks (0) Thanks(0)   Quote DaveCinIN Quote  Post ReplyReply Direct Link To This Post Posted: 21 Jul 2012 at 9:39pm
Thanks. I had a couple of ideas, but I like the redrilling better.
Back to Top
DaveCinIN View Drop Down
Orange Level
Orange Level


Joined: 12 Sep 2009
Location: Kouts, IN
Points: 629 		Post Options Post Options   Thanks (0) Thanks(0)   Quote DaveCinIN Quote  Post ReplyReply Direct Link To This Post Posted: 10 Aug 2012 at 6:17pm
Found a new governor spring assembly. Installed it and I now have both high and low idle at the proper rpm and the governor works just as it should.
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.053 seconds.


Help Support the
Unofficial Allis Forum