Farm Equipment - 190XT Gas governor spring

Print Page | Close Window

190XT Gas governor spring

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=53920
Printed Date: 10 Sep 2025 at 5:12am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: 190XT Gas governor spring

Posted By: DaveCinIN
Subject: 190XT Gas governor spring
Date Posted: 20 Jul 2012 at 11:16pm

I think I need a governor spring for my 190XT gas. If I adjust the high idle according to the book, the low idle is too high (won't go to the stop on the carb). If I set it so it will go to low idle, then it will only rev to 2000 rpm. Called SLI and AGCO replaced the spring assembly (2 Parts) with 3 seperate parts and they are very proud of them. They now have an auxillary spring. Anyway I need a good spring if anyone has one.

Replies:

Posted By: DrAllis
Date Posted: 21 Jul 2012 at 5:21pm

If you have to, you can drill a new hole on the governor arm up 1/2" or so (from the original hole) to reach your high idle specs. It will require reworking the throttle cable anchor bracket just a bit to allow for a straight line, but that can be done easily.

Posted By: DaveCinIN
Date Posted: 21 Jul 2012 at 9:39pm

Thanks. I had a couple of ideas, but I like the redrilling better.

Posted By: DaveCinIN
Date Posted: 10 Aug 2012 at 6:17pm

Found a new governor spring assembly. Installed it and I now have both high and low idle at the proper rpm and the governor works just as it should.