![]() |
This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity. | |||||
| The Forum | Parts and Services | Unofficial Allis Store | Tractor Shows | Serial Numbers | History | |
7030 Over full |
Post Reply
|
| Author | |
summertime
Bronze Level
Joined: 30 Mar 2014 Location: Luray Va. Points: 8 |
Post Options
Thanks(0)
Quote Reply
Topic: 7030 Over fullPosted: 29 May 2017 at 5:09am |
|
Transmission oil level is over full now. Rear end is low. Where is this transferring of oil happening?
|
|
![]() |
|
| Sponsored Links | |
![]() |
|
MACK
Orange Level
Joined: 17 Nov 2009 Points: 7664 |
Post Options
Thanks(0)
Quote Reply
Posted: 29 May 2017 at 8:30am |
|
A lot of places, but most common hydraulic pump and seal on pump drive shaft at pumps. MACK
|
|
![]() |
|
DrAllis
Orange Level Access
Joined: 12 Sep 2009 Points: 22337 |
Post Options
Thanks(0)
Quote Reply
Posted: 29 May 2017 at 8:32am |
|
What does "now" mean ?? Like you've been doing something to the tractor and NOW it has this problem??? Tractor has to be on a very level surface and sitting for 15 minutes to get accurate readings. Trans dipstick has to be wiped clean and checked on both sides of the stick. Until you correct oil levels, use the tractor and find it really has done it again, I'm not absolutely sure there is a problem. Oil transfer usually goes the other way on those tractors.
|
|
![]() |
|
summertime
Bronze Level
Joined: 30 Mar 2014 Location: Luray Va. Points: 8 |
Post Options
Thanks(0)
Quote Reply
Posted: 29 May 2017 at 8:52am |
|
First time to have it out this spring. Hook to 20 ft Batwing bushhog.Wouldn't raise lift cylinder after about 5 hours use. Checked oil at sight glass an couldn't see any. Let sit 2 hours an checked again​ that's when I noticed transmission was over full.Changed all oils an filters last fall.
|
|
![]() |
|
DrAllis
Orange Level Access
Joined: 12 Sep 2009 Points: 22337 |
Post Options
Thanks(0)
Quote Reply
Posted: 29 May 2017 at 2:33pm |
|
Well, I'd think for the hydraulic oil to be low enough to affect the lifting, your power steering should have acted up and that would mean being maybe 10 gallons low on oil??? I don't think there's room for 10 gallons of oil to transfer into the tranny. I think you have an oil leak on the batwing and your tranny being overfull?? how much more on the dipstick?? an inch??
|
|
![]() |
|
MACK
Orange Level
Joined: 17 Nov 2009 Points: 7664 |
Post Options
Thanks(0)
Quote Reply
Posted: 29 May 2017 at 9:45pm |
|
Transmission dip stick is to the back, so if front of tractor is a little up hill, the dip stick will show over full. Front could have been down hill a little when filled so now shows over full. MACK
|
|
![]() |
|
Post Reply
|
|
|
Tweet
|
| Forum Jump | Forum Permissions ![]() You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |