![]() |
This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity. | |||||
The Forum | Parts and Services | Unofficial Allis Store | Tractor Shows | Serial Numbers | History |
BRAKE LOCKING 200 ALLIS |
Post Reply ![]() |
Author | |
ac-mike ![]() Silver Level ![]() Joined: 14 Sep 2009 Location: Kentucky Points: 277 |
![]() ![]() ![]() ![]() ![]() Posted: 17 Jan 2017 at 8:16am |
I HAVE A CUSTOMERS 200 ALLIS IN SHOP. CUSTOMER SAYS THE RIGHT BRAKE LOCKS UP AND HAVE TO ROCK IT TO GET IT TO RELEASE. THIS IS A LATER STYLE 200 BRAKE SET UP. USUALLY THIS IS CAUSED BY, OIL LEAK,OR PADS WORN OUT, OR DISTANCE BETWEEN INNER AND OUTER BRAKE DRUM PARTS BECOMES TO WIDE. THE EARLIER STYLE BRAKE SETUP IS SIMILAR TO 100 SERIES TRACTORS. SHOP MANUAL GIVES ALLOWABLE DIMISION BETWEEEN BRAKE DRUMS.
MY SHOP MANUAL GIVES NO DIMISION BETWEEN BRAKE DRUM PLATES ON TRACTORS WITH THE NEWER STYLE BRAKES. SHOULD THIS BE A CONCERN? WHAT ELSE MIGHT CAUSE BREAK TO LOCK UP? BRAKE DISCS SHOW VERY LITTLE WEAR AND NO OIL LEAK. |
|
![]() |
|
Sponsored Links | |
![]() |
|
old farmer ![]() Silver Level Access ![]() ![]() Joined: 12 Oct 2011 Location: Sturgis, Mich Points: 341 |
![]() ![]() ![]() ![]() ![]() |
Could be a problem in the rear end. Have seen this before on some tractors.
|
|
![]() |
|
Tony Elo ![]() Orange Level ![]() ![]() Joined: 13 Sep 2009 Location: guelph ontario Points: 256 |
![]() ![]() ![]() ![]() ![]() |
Is it the style of brakes like the 7000 have? Discs with ball bearings on a taper to push them out? if so,make sure where the ball bearings slide is smooth,also check them for any flat spots
|
|
![]() |
|
Lynn Marshall ![]() Orange Level Access ![]() ![]() Joined: 13 Sep 2009 Location: Dana, Iowa Points: 2381 |
![]() ![]() ![]() ![]() ![]() |
My belief is that the splines get worn in the discs (sharp) and cause this problem. Look at that area closely.
|
|
![]() |
|
Rhoadesy_65 ![]() Bronze Level ![]() ![]() Joined: 28 Jul 2019 Location: Versailles, OH Points: 151 |
![]() ![]() ![]() ![]() ![]() |
Do you remember what ended being the fix for this? Mine does have oil in one side, but the other is dry
|
|
Farmin' with 1981 7010 PD, 1983 6080, 1983 8010, Gleaner R42 in Darke County OH
|
|
![]() |
Post Reply ![]() |
|
Tweet
|
Forum Jump | Forum Permissions ![]() You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |