![]() |
This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity. | |||||
The Forum | Parts and Services | Unofficial Allis Store | Tractor Shows | Serial Numbers | History |
WD/WD45 Question |
Post Reply ![]() |
Author | |
Dennis J OPKs ![]() Orange Level ![]() Joined: 12 Sep 2009 Location: Overland Park, Points: 533 |
![]() ![]() ![]() ![]() ![]() Posted: 9 hours 16 minutes ago at 8:52am |
I've only seen this on 2 tractors. One was mine & the other was at a show in Ottawa KS. The right rear corner of the platform was cut out-about a 5- or 6-inch section, smooth cut, not a torch job. I don't have a photo. I immediately replaced the platform, and the old one went to scrap. This was obviously done to gain clearance for some rear implement, mounted or pull type. That's under the seat so it couldn't have been very long. Both of these sightings were in KS which means nothing. So, this question is thrown out there for your answer. Someone must know. Thanks.
|
|
![]() |
|
Sponsored Links | |
![]() |
Post Reply ![]() |
|
Tweet
|
Forum Jump | Forum Permissions ![]() You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |