This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


190 xt not moving
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
youngorange2000 View Drop Down
Silver Level
Silver Level


Joined: 27 Mar 2019
Location: eastcentral MN
Points: 308 		Post Options Post Options   Thanks (0) Thanks(0)   Quote youngorange2000 Quote  Post ReplyReply Direct Link To This Post Topic: 190 xt not moving
    Posted: 25 Apr 2020 at 10:09am
was moving -driving but had bad pinion gear.Tore ractorapart replaced with a used rear half.When we were putting the 2 halves back together bushing on rear shaft seemed tight.now tractor stalls out if we let the clutch out.Any ideas.THANKS
Back to Top
Sponsored Links


Back to Top
DrAllis View Drop Down
Orange Level Access
Orange Level Access


Joined: 12 Sep 2009
Points: 19563 		Post Options Post Options   Thanks (0) Thanks(0)   Quote DrAllis Quote  Post ReplyReply Direct Link To This Post Posted: 25 Apr 2020 at 7:20pm
You installed a used "rear end" into your 190XT. Bushing on the rear shaft seems tight ??  I have no idea what you're talking about. Even if the transmission (inside the rear end) can't rotate, you should be able to leave the Power Director clutch lever in Neutral and let out on the foot clutch. If this doesn't happen and with the Power Director in neutral it still kills the engine, your problem is in the Power Director clutch or the large (3 inch diameter) bushing on the front of the Power Director clutch fits TIGHT onto the hollow shaft  ?? If you had to draw the rear end together to the torque housing using bolts, that shouldn't be.

Edited by DrAllis - 25 Apr 2020 at 7:21pm
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.064 seconds.


Help Support the
Unofficial Allis Forum