| Author |
 Topic Search  Topic Options
|
jstewart 
Bronze Level
Joined: 14 Sep 2009
Location: NE Missouri
Points: 43
|
 Post Options
 Thanks(0)
 Quote  Reply
 Topic: 8050 Hydraulic Remotes are Slow
Posted: 11 Apr 2012 at 9:43am |
Tried to turn the t-handle on the remote valve, didn't seem to make a difference. Are they threaded; or spring loaded and I need to push in on them as I turn to make them catch a notch or something. As I was standing at the rear of the tractor I was turning them counter-clockwise, and I turned them quite a bit, but it didn't seem to make a difference. Thanks for any help. Jared
|
 |
|
Sponsored Links
|
|
|
DrAllis
Orange Level Access
Joined: 12 Sep 2009
Points: 21853
|
Post Options
Thanks(0)
Quote Reply
Posted: 11 Apr 2012 at 11:38am |
|
The roll pin on the flow control spool should have a long side and a short side.....long side straight down is fast......long side straight up is slow.
|
|
jstewart
Bronze Level
Joined: 14 Sep 2009
Location: NE Missouri
Points: 43
|
Post Options
Thanks(0)
Quote Reply
Posted: 11 Apr 2012 at 12:54pm |
|
Thanks a million DrAllis, I'll give that a try tonight.
|
|
DrAllis
Orange Level Access
Joined: 12 Sep 2009
Points: 21853
|
Post Options
Thanks(0)
Quote Reply
Posted: 11 Apr 2012 at 7:20pm |
|
Now that I'm home and relaxed, I gave you bad advice.....Long side down and up is for 7000 series........I think the 8000's were 3 o'clock and 9 o'clock.....only one-half turn from fast to slow.......you can turn them 100 times and it does nothing, it's where you set them at.......put one and 3 o'clock and the other at 9 o'clock and you'll figure it out. THIS INFO IS IN YOUR OWNERS MANUAL with pictures.
|
|
darrel in ND
Orange Level
Joined: 22 Nov 2009
Location: Hebron, ND
Points: 8716
|
Post Options
Thanks(0)
Quote Reply
Posted: 11 Apr 2012 at 10:53pm |
|
Look under the seat, towards the back of the cab. Could possibly be a flow control for one of the remotes there with a decal showing fast and slow. Orientation of the rest of the remotes is the same. Darrel
|
|
BobHnwO
Orange Level
Joined: 16 Sep 2009
Location: Jenera Ohio
Points: 693
|
Post Options
Thanks(0)
Quote Reply
Posted: 12 Apr 2012 at 4:15am |
|
The handle on my 7060 was on backwards!
|
|
Why do today what you can put off til tomorrow.
|
|
jstewart
Bronze Level
Joined: 14 Sep 2009
Location: NE Missouri
Points: 43
|
Post Options
Thanks(0)
Quote Reply
Posted: 12 Apr 2012 at 6:25am |
Thanks for the replies guys. I didn't take much time to mess with them last night, I put both of them down and one seemed faster than the other so I switched my raise/lower to that remote. I can attest to turning them and nothing happening, I about wore out my fingers the other day turning them to no avail. There is a picture under the seat with a fast/slow, I assumed (know what that will do) it was indicating the direction to turn the t-handle, not indicating a position. I'll get back to it again tonight if it doesn't start raining early. Thanks again, Jared
|
|
