This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


WD hand clutch
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
Bill_MN View Drop Down
Orange Level
Orange Level
Avatar

Joined: 12 Sep 2009
Location: Sioux Falls, SD
Points: 1471 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Bill_MN Quote  Post ReplyReply Direct Link To This Post Topic: WD hand clutch
    Posted: 20 Jan 2016 at 6:31pm
Has anyone tried making a WD/WD45 hand clutch with 4 or more discs? Just sitting here bored tonight curious if one could make a stronger clutch for pulling beyond the WD45 3 disc setup? Would probably need spacers where the shims normally go and machining of the collar to allow extra space.
1951 WD #78283, 1918 Case 28x50 Thresher #76738, Case Centennial B 2x16 Plow
Back to Top
Sponsored Links


Back to Top
DrAllis View Drop Down
Orange Level Access
Orange Level Access


Joined: 12 Sep 2009
Points: 21834 		Post Options Post Options   Thanks (0) Thanks(0)   Quote DrAllis Quote  Post ReplyReply Direct Link To This Post Posted: 20 Jan 2016 at 6:53pm
Maybe, but the splines on the transmission input shaft are only so long, there may not be enough for a 4th disc. Anyway, serious Pullers eliminate the hand clutch for zero slippage problems and a loss of 25 to 30 pounds in weight.
Back to Top
norm[ind] View Drop Down
Orange Level
Orange Level


Joined: 29 Oct 2010
Location: bourbon,ind
Points: 2992 		Post Options Post Options   Thanks (0) Thanks(0)   Quote norm[ind] Quote  Post ReplyReply Direct Link To This Post Posted: 20 Jan 2016 at 7:46pm
  can put 2 hand clutch connectors and bolt them together hve done some for that purpose
Back to Top
SteveM C/IL View Drop Down
Orange Level Access
Orange Level Access


Joined: 12 Sep 2009
Location: Shelbyville IL
Points: 8612 		Post Options Post Options   Thanks (0) Thanks(0)   Quote SteveM C/IL Quote  Post ReplyReply Direct Link To This Post Posted: 20 Jan 2016 at 10:17pm
Had a 4 plate setup for a while.Had to make shorter links for the over center mechanism and welded a spacer to where the shims go.Think the link difference and spacer thickness was 5/16.Takes 2 shortened springs per hole with short wire inside to help keep aligned.Just remember the plates have the hubs mounted in different ways depending on location so you have to use the correct ones.

Edited by SteveM C/IL - 20 Jan 2016 at 10:19pm
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.063 seconds.


Help Support the
Unofficial Allis Forum