| Author |
 Topic Search  Topic Options
|
jmnuren 
Bronze Level
Joined: 12 May 2012
Location: Michigan
Points: 38
|
 Post Options
 Thanks(0)
 Quote  Reply
 Topic: 7050 Hydraulic Problem
Posted: 30 Jul 2012 at 11:01am |
|
When at idle the 1800 rpm high pressure light comes on and the hydraulic cooler line vibrates, and after a few minute the Hydro oil will come out of the rear fill cap. If you raise the thottle light goes out and there isn't any problem. Any help would be great.
|
 |
|
Sponsored Links
|
|
|
DrAllis
Orange Level Access
Joined: 12 Sep 2009
Points: 21909
|
Post Options
Thanks(0)
Quote Reply
Posted: 30 Jul 2012 at 8:40pm |
|
With hot oil the 1800 light will probably be on when below 1800 rpm....that's what is supposed to do. Over 1800 rpm the light should be off. I have no idea what your problem is with oil coming out of the fill cap on the rearend. Did you just buy this tractor??
|
|
MACK
Orange Level
Joined: 17 Nov 2009
Points: 7664
|
Post Options
Thanks(0)
Quote Reply
Posted: 30 Jul 2012 at 9:58pm |
Take the top sight glass out and let the over filled oil run out. Then remove both sight glasses out and clean them so you can see when it is full.
The 1800 light could stay on above 1800 by the tack because the pulleys wear causing the alt. to run faster causing the tack to show more RPMs than it is actualy running. MACK
|
|
SteveM C/IL
Orange Level Access
Joined: 12 Sep 2009
Location: Shelbyville IL
Points: 8629
|
Post Options
Thanks(0)
Quote Reply
Posted: 30 Jul 2012 at 10:30pm |
|
I have heard that some generic hytran oils don't mix well with others causing foaming...but i have no idea if that is factual....
|
|
jmnuren
Bronze Level
Joined: 12 May 2012
Location: Michigan
Points: 38
|
Post Options
Thanks(0)
Quote Reply
Posted: 31 Jul 2012 at 11:40am |
|
Purchased tractor in May with a bad motor. Had not been used for ten years, grandson got it free and put in the field, about 50 hours later the engine started blowing alot of smoke from the valve cover vent. Replaced #1 piston "hole in it" from a bad injector, rebuilt all injectors,, check all rod bearings, rebuilt head. The tractor runs strong. He said not to idle it all the way down and I shouldnt have any problems with light coming on.
The tach doesnt work.
The oil is just below high mark on dipstick under seat, I will check the sight glass.
Why would the hydrualic line leading to the radiator vibrate when it was at idle? I had only ran tractor for 5 miles on road, the oil should not have been thay hot, when I idled it down it sounds like a bypass valve.
Also remotes are quick one way and slow the other.
|
|
Ron(AB)
Orange Level
Joined: 27 Dec 2009
Location: Alberta
Points: 962
|
Post Options
Thanks(0)
Quote Reply
Posted: 02 Aug 2012 at 12:25am |
|
Regarding the remotes - the hyd cables are not adjusted properly if they work better with the lever pushed one way but not the other. Adjust the jam nuts on one or both of the cable ends, or get a new cable(s) if they are getting hard (sticky) to push.
Re: vibrating hyd line - could the system have air leaking in? Which might explain the oil coming out of the fill cap?
|
|
Dave in il
Orange Level
Joined: 22 Sep 2009
Location: Manville Il
Points: 1748
|
Post Options
Thanks(0)
Quote Reply
Posted: 02 Aug 2012 at 11:15am |
|
Just a thought, are all the line clamps tight and the insulators in place?
|
|
AGCO My Allis Gleaner Company
|
|
