Series 3 flexhead on K2

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   Wondering if anyone has put a series 3 flexhead (313) from a F2/3 onto a K2?

My concern isn’t about the hydraulic or electronic side of things.  That’s secondary, my question is actually fitting it onto the combine.

Were they built like earlier models to move the hooks in?  Drive shafting is also a concern. 

We are pretty darn handy with the welder and torch, so that can make just about anything possible, but just wondering if anyone has been through the process.

If I can get it locked onto the combine, and power through the shaft, the rest is down hill.

	This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
	The Forum	Parts and Services	Unofficial Allis Store	Tractor Shows	Serial Numbers	History

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
67-d10 Members Profile Send Private Message Find Members Posts Add to Buddy List Bronze Level Joined: 19 Nov 2022 Location: NESD Points: 30	Post Options Post Reply Quote 67-d10 Report Post Thanks(0) Quote Reply Topic: Series 3 flexhead on K2 Posted: 3 hours 3 minutes ago at 3:05pm
	Wondering if anyone has put a series 3 flexhead (313) from a F2/3 onto a K2? My concern isn’t about the hydraulic or electronic side of things. That’s secondary, my question is actually fitting it onto the combine. Were they built like earlier models to move the hooks in? Drive shafting is also a concern. We are pretty darn handy with the welder and torch, so that can make just about anything possible, but just wondering if anyone has been through the process. If I can get it locked onto the combine, and power through the shaft, the rest is down hill.

Sponsored Links

AC7060IL Members Profile Send Private Message Find Members Posts Add to Buddy List Orange Level Joined: 19 Aug 2012 Location: central IL Points: 3539	Post Options Post Reply Quote AC7060IL Report Post Thanks(0) Quote Reply Posted: 54 minutes ago at 5:14pm
	1st. Relocate both of 313’s top pipe hooks & lower wedge hooks inward to align to K/K2 feeder housing. After that’s accomplished, then bolt in 2 custom made side filler sheets (5”?) to each side to enclose F/F2-3 gaps. Header feeder opening should measure same height for both K & F….? F is 10” wider (1 straw walker) than K. 2nd. Lengthen 313’s left side drive shaft. Think that shaft’s outer drive sprocket is probably keyed? Try to Fab-install a short(5-6”?)shaft adapter that may slide over original keyed end (ie original drive sprocket that fits keyed end with a welded black pipe extension to it & then another drive sprocket welded to it other end where it accept K2’s drive chain). This option along with 1st step above renders 313 adaptable/readily swappable between F & K. If extending shaft with more shaft, locate a good non-bearing area before drive sprocket end to cut & lengthen it. Now it’s set for K only though…. Whichever design chosen, the drive shaft is not a high rpm shaft so good/decent alignment should suffice? 3rd. Your local combine salvage yard may have the required hydraulic/electrical components from parts combine.(f3/M3/L3?) that could be swapped into K2. Edited by AC7060IL - 14 minutes ago at 5:54pm