Replacing auger drive belt on model 72 combine
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=169693
Printed Date: 30 Apr 2024 at 1:42am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: Replacing auger drive belt on model 72 combine
Posted By: N186364
Subject: Replacing auger drive belt on model 72 combine
Date Posted: 01 Apr 2020 at 7:22pm
| The unloading auger drive belt on my model 72 combine needs to be replaced ( the parts book calls it : belt, unloading conveyor ). Does anyone have a good " how to " on this especially regarding how to get the new belt around the PTO drive shaft? Also does anyone know the size of the belt? |
Replies:
Posted By: wlambs
Date Posted: 02 Apr 2020 at 6:46am
| HAVE TO UNBOLT THE PTO FRONT SLIDE BELT ON THEN THE BACK. ALLCROP HARVESTER HAS THEM TOM YAZZ |
Posted By: TomYaz
Date Posted: 02 Apr 2020 at 12:05pm
What he said. Specifically part # 1 below: ------------- If its not an All-Crop, it all crap! |
Posted By: Ryan Renko
Date Posted: 02 Apr 2020 at 7:22pm
| I actually had to replace a leaky front oil seal on my gearbox and while I had the front drive shaft removed it was a perfect time to replace the auger belt. Ryan |
Posted By: N186364
Date Posted: 02 Apr 2020 at 7:32pm
| That's great. Thank you all. Tom, a picture says a thousand words. I'll take a run at this in a day or so. Do I have to worry about a torque value when I re-assemble the PTO shaft? |
Posted By: den/southern illinoi
Date Posted: 02 Apr 2020 at 8:03pm
|
I have had instances like this where I put two belts on at the same This is mostly when the belts go bad quickly. I install one as is needed and tie the second out of the way until needed. I know that this belt does not get extensive use but just thought I'd throw it out there. Den ------------- Own 5 720 garden tractors with associated equipment,1 620 garden tractor, 4 wheel 20 2-5015, 5020 and associated equipment and 2 electric forklifts. |
Posted By: N186364
Date Posted: 02 Apr 2020 at 9:42pm
| I did look at the " allcropharvester.com " web site and the auger belt is listed with a part number but also ( very helpfully ) the letter/number combo for this belt which is B61. Thanks. |
Posted By: TomYaz
Date Posted: 03 Apr 2020 at 3:13pm
|
NP. Torgue? Dont think so on the torque---I have never heard of such a requirement ------------- If its not an All-Crop, it all crap! |