SC blade cutting edge
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=150404
Printed Date: 25 Jun 2025 at 11:02am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: SC blade cutting edge
Posted By: Darrell, Jr. (MN)
Subject: SC blade cutting edge
Date Posted: 12 May 2018 at 9:29pm
Is anyone making the bolt on cutting edges for the SC blade? I am in need of one. I will also need the edges for the extensions too. Thanks in advance.
|
Replies:
Posted By: Ryan Renko
Date Posted: 12 May 2018 at 9:34pm
|
If I am not mistaken I read before that Cat makes one that fits? Hopefully someone else will chime in. Ryan
|
Posted By: truckerfarmer
Date Posted: 12 May 2018 at 10:35pm
Standard road grader cutting edges bolt right up to the main blade.
-------------
Looking at the past to see the future.
'53 WD, '53 WD45, WD snap coupler field cultivator, #53 plow,'53 HD5B dozer
Duct tape.... Can't fix stupidity. But will muffle the sound of it!
|
Posted By: dawntreader74
Date Posted: 12 May 2018 at 11:56pm
|
one for western snow blade works an looks good also' an price is right on them also.
|
Posted By: AaronSEIA
Date Posted: 13 May 2018 at 5:30am
I bought one from Cat a few years ago. I forget the number now but at the time it was only around $60. The top lip on it was maybe 1/4" too tall as it didn't quite roll in tight to the blade. If you search the forums for my screen name and snap coupler blade, you should be able to find the discussion and pictures I posted.
AaronSEIA
|
Posted By: Dave (NE)
Date Posted: 13 May 2018 at 11:05am
|
Yes there has been discussions on this topic in the past. Seems that Cat makes a cutting edge that will work and someone mentioned there is a lighter cutting edge they make that works and is less expensive. A few years ago, I bought the cutting edge from Cat and had to cut it down off each end to 18" for the extensions. 3 out of 4 holes matched up and could be used. Still have a chunk of the edge from the center left. Don't know what I'll ever do with it, but it's a nice piece of iron.
|
Posted By: Dave (NE)
Date Posted: 13 May 2018 at 11:51am
|
Found an old receipt for the cutting edge I used for the extensions. Part #8D-2786.
|
Posted By: Dave (NE)
Date Posted: 13 May 2018 at 11:59am
|
Here is a prior discussion on the cutting edge. Part #7T-1633H was the lower priced cutting edge. http://www.allischalmers.com/forum/rear-mounted-blade-replacement-cutting-edge_topic115463_post934958.html?KW=cutting+edge#934958" rel="nofollow - http://www.allischalmers.com/forum/rear-mounted-blade-replacement-cutting-edge_topic115463_post934958.html?KW=cutting+edge#934958
|
|