8050 rear lights.
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=105872
Printed Date: 11 Sep 2025 at 7:37am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: 8050 rear lights.
Posted By: AaronH
Subject: 8050 rear lights.
Date Posted: 08 May 2015 at 7:42pm
|
all of the rear lights went out the other night. is there a fuse box, and where is it or is it in the switch?
|
Replies:
Posted By: DSeries4
Date Posted: 08 May 2015 at 9:43pm
Not familiar with the 8000s, but there should be a fuse somewhere for the lights - check your manual. If it is good, try bypassing the switch. If they come on, your switch is no good.
-------------
'49 G, '54 WD45, '55 CA, '56 WD45D, '57 WD45, '58 D14, '59 D14, '60 D14, '63 D15D, '66 D15II, '66 D21II, '67 D17IV, '67 D17IVD, '67 190XTD, '73 620, '76 185, '77 175, '84 8030, '85 6080
|
Posted By: randy
Date Posted: 09 May 2015 at 6:16am
I think there is fuse block between the clutch and brake petals behind the panel. 4 bolts on the panel. Not sure if the light fuse is there, hope so.
-------------
CA WD WD45 D17 D17 Diesel 7060 8050 8070
|
Posted By: Leon B MO
Date Posted: 09 May 2015 at 7:05am
|
Sounds like it's in the switch, loose wire or burnt contact. If any of the front lights work I don't think it's a fuse. The whole light switch is run off of one fuse, I think. I would start by taking the small panel for switch/blinker out and use a test light to see what you find. Leon B
-------------
Uncle always said "Fill the back of the shovel and the front will take care of itself".
|
Posted By: JET8070
Date Posted: 12 May 2015 at 9:46pm
|
Fuse panel where randy says for low serial number(2-5/16 bolts). All breakers for high serial # in same place. Switch should be fine if all front lights come on. One fuse should not take out all four rear lights and no fronts on stadium light tractor s unless someone has bridged some circuits. If fuses are good check for harness ruby through near power steering motor.
|
Posted By: Kevin in WA
Date Posted: 12 May 2015 at 11:48pm
|
Check harness connector by the steering motor.
|
Posted By: Unit3
Date Posted: 13 May 2015 at 8:38am
Remove side panels and tin plate at rear of engine. 6 small screws. In behind is a 5 or 6 pin connector. They get old and burn up. After fixing yours, come do our 8070. Lost our rear lights as well.
-------------
2-8070FWA PS/8050PS/7080/7045PS/200/D15-II/2-WD45/WD/3-WC/UC/C
|
|