2-12 plow depth link

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   My model 4 has long rear landslide. 
My question is about the link that goes from the axle lift to the depth control lever(  left side in Tractor seat) .
I cannot lift the plow with lever to plow a 6 inch depth furrow. I’m going to deep. The lever is all the way down locked. 
I was told that the model 2 has a link with three holes in it. 
If you’re familiar with that plow could you please verify that. 
I would also like to know the distance between each hole ? This would be a great help. 

I measure mine and it was 17.5 inches approximately center of holes in link rectangle lift bar .

My manual sayes that the tires should be 5.00-16. ( 25.5 outside diameter) I currently have 4.6-16 motorcycles tires which are not quit 25 inches out side diameter. 

Thanks for your comments 

	This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
	The Forum	Parts and Services	Unofficial Allis Store	Tractor Shows	Serial Numbers	History

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
560Dennis Members Profile Send Private Message Find Members Posts Add to Buddy List Bronze Level Joined: 30 Apr 2011 Location: NE OHIO Points: 119	Post Options Post Reply Quote 560Dennis Report Post Thanks(0) Quote Reply Topic: 2-12 plow depth link Posted: 28 May 2025 at 7:22pm
	My model 4 has long rear landslide. My question is about the link that goes from the axle lift to the depth control lever( left side in Tractor seat) . I cannot lift the plow with lever to plow a 6 inch depth furrow. I’m going to deep. The lever is all the way down locked. I was told that the model 2 has a link with three holes in it. If you’re familiar with that plow could you please verify that. I would also like to know the distance between each hole ? This would be a great help. I measure mine and it was 17.5 inches approximately center of holes in link rectangle lift bar . My manual sayes that the tires should be 5.00-16. ( 25.5 outside diameter) I currently have 4.6-16 motorcycles tires which are not quit 25 inches out side diameter. Thanks for your comments

Sponsored Links

jiminnd Members Profile Send Private Message Find Members Posts Add to Buddy List Orange Level Joined: 16 Sep 2009 Location: Rutland ND Points: 2278	Post Options Post Reply Quote jiminnd Report Post Thanks(0) Quote Reply Posted: 28 May 2025 at 9:20pm
	I think I have the same plow, will check tomorrow and measure. I think that is what mine is, it measures 17 inches hole to hole, I have 6.00 16 tires off a WD on mine and it works fine. Edited by jiminnd - 20 hours 16 minutes ago at 11:00am
	1945 C, 1949 WF and WD, 1981 185, 1982 8030, unknown D14(nonrunner)