This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Construction and other equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


HD16AC oil leak
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
sdtplus4 View Drop Down
Bronze Level
Bronze Level


Joined: 04 Jan 2017
Location: ky
Points: 13 		Post Options Post Options   Thanks (0) Thanks(0)   Quote sdtplus4 Quote  Post ReplyReply Direct Link To This Post Topic: HD16AC oil leak
    Posted: 27 Oct 2017 at 10:00am
Im losing transmission fluid out the track pivot pin cap, according to my parts breakdown there is a wick that goes from pin into transmission case. How hard is this to replace? Do I have to remove the track assembly or can I just support the dozer and  pull the caps and pin??? Im running 15w40 in the transmission 
Back to Top
Sponsored Links


Back to Top
CAL(KS) View Drop Down
Orange Level
Orange Level


Joined: 18 Sep 2009
Location: Chapman, KS
Points: 3735 		Post Options Post Options   Thanks (0) Thanks(0)   Quote CAL(KS) Quote  Post ReplyReply Direct Link To This Post Posted: 27 Oct 2017 at 11:07am
its been awhile since ive had mine off but IIRC  the caps come off and the pin has drop down to be free of the dowel.  The wick is located inside the dowel that goes between the housing and the pin.  When I had mine off I had to move the whole truck frame foreward to remove the sprocket so I also had the axle shaft loose from the frame.  I don't know if the pin will drop out with the axle shaft attached or not.  Likely your pins are worn and/or the seals on either side are bad.   

Edited by CAL(KS) - 27 Oct 2017 at 11:10am
Me -C,U,UC,WC,WD45,190XT,TL-12,145T,HD6G,HD16,HD20

Dad- WD, D17D, D19D, RT100A, 7020, 7080,7580, 2-8550's, 2-S77, HD15
Back to Top
sdtplus4 View Drop Down
Bronze Level
Bronze Level


Joined: 04 Jan 2017
Location: ky
Points: 13 		Post Options Post Options   Thanks (0) Thanks(0)   Quote sdtplus4 Quote  Post ReplyReply Direct Link To This Post Posted: 27 Oct 2017 at 3:05pm
I will check out the seals thanks
Back to Top
sdtplus4 View Drop Down
Bronze Level
Bronze Level


Joined: 04 Jan 2017
Location: ky
Points: 13 		Post Options Post Options   Thanks (0) Thanks(0)   Quote sdtplus4 Quote  Post ReplyReply Direct Link To This Post Posted: 28 Oct 2017 at 7:07pm
I pulled my cap and there was nothing in the dowel pin , I could run a wire into transmission case, so I put in a piece of felt and hope it holds.
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.047 seconds.


Help Support the
Unofficial Allis Forum