Another hydraulic question - WD

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   My pump leaks where i circled it in the picture....Does this shaft seal come out easily 
without tearing down the pump? i dont want to tear down the pump it works ok......
since im in there i might as well replace the seal in the other small shaft to the left of it
as long as i dont have to tear it down. wouldnt mind replacing it dont like getting my garage floor all wet with oil and tracking it into the house.

	This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
	The Forum	Parts and Services	Unofficial Allis Store	Tractor Shows	Serial Numbers	History

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
G226WD Members Profile Send Private Message Find Members Posts Add to Buddy List Bronze Level Joined: 06 Jul 2011 Location: Canada Points: 34	Post Options Post Reply Quote G226WD Report Post Thanks(0) Quote Reply Topic: Another hydraulic question - WD Posted: 25 Jun 2012 at 7:11pm
	My pump leaks where i circled it in the picture....Does this shaft seal come out easily without tearing down the pump? i dont want to tear down the pump it works ok...... since im in there i might as well replace the seal in the other small shaft to the left of it as long as i dont have to tear it down. wouldnt mind replacing it dont like getting my garage floor all wet with oil and tracking it into the house.

Sponsored Links

TedBuiskerN.IL. Members Profile Send Private Message Find Members Posts Add to Buddy List Orange Level Joined: 11 Sep 2009 Location: Davis, IL. Points: 1959	Post Options Post Reply Quote TedBuiskerN.IL. Report Post Thanks(0) Quote Reply Posted: 25 Jun 2012 at 8:37pm
	Check the linkages inside that housing while you have it apart. The pivot holes wear and sometimes need to be welded up and redrilled, or replaced. Good luck with that project.
	Most problems can be solved with the proper application of high explosives.

SteveM C/IL Members Profile Send Private Message Find Members Posts Add to Buddy List Orange Level Access Joined: 12 Sep 2009 Location: Shelbyville IL Points: 8636	Post Options Post Reply Quote SteveM C/IL Report Post Thanks(0) Quote Reply Posted: 26 Jun 2012 at 12:34am
	U will have to pull the pump off to get that rear section off.With back section off then disassemble stuff on than shaft and pull out shaft.Dig out seal and install new and reassemble everything. Not too hard but can't guarantee no mess. Drain plug in front of pto box for hyd and don't forget the little one on bottom of that hsg you're goin to re-seal. Put down lots of news paper. Flatten(taper) the end of 4 nails to wedge in the top side of plunger levers(push plungers in and lock lever)when putting back on tractor. It gives you room to fish pump in by keeping rollers out of the way.Once you get the rollers past the gasket surface you can pull the nails and release the plungers. While you're there you just as well replace the other shaft seal. Edited by SteveM C/IL - 26 Jun 2012 at 12:35am