This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity. | ||||||
The Forum | Parts and Services | Unofficial Allis Store | Tractor Shows | Serial Numbers | History |
HD6G engine |
Post Reply |
Author | |
agengineer
Bronze Level Joined: 17 Apr 2011 Location: Piedmont OK Points: 29 |
Post Options
Thanks(0)
Posted: 17 Apr 2011 at 8:35am |
I have found a HD6g with a hd3400? engine w/dry clutch. I thought there were some other engines in the HD6 crawlers. Could a 3-53 detroit fit in there?
Any help would be appreciated. I am new to this forum.
|
|
Sponsored Links | |
Lee Bradley
Bronze Level Joined: 13 Oct 2009 Location: Kingston, WA Points: 115 |
Post Options
Thanks(0)
|
The HD-6 was a re-engined HD-5 which used the 2-71 Detroit. I would go with a 3-71 if you could find one. I like the sound of the 2 cycle Detroits but the 53 series is a little loud for me.
|
|
superchief
Bronze Level Joined: 16 Apr 2011 Location: Missouri Points: 33 |
Post Options
Thanks(0)
|
Hi, agengineer, I can't help you on your find. The HD344 engine I purchased to put is my HD6G with wet clutch will not work for me. This engine did have a dry clutch. and was operated on a dozer, the crank pulley is large and will not let me connect the wishbone for the hydraulic pump. It might cause you the same problem? I guess I will start looking now to find a buyer. The engine looks good, has compression, new/rebuilt injection pump, and new valve cover gaskets and head gasket, a lot of work has apparantly been done to this engine plus it has a turbo charger installed. For your information. Superchief
|
|
agengineer
Bronze Level Joined: 17 Apr 2011 Location: Piedmont OK Points: 29 |
Post Options
Thanks(0)
|
Ithink I can use that one. I have the pulleys from the engine and on this one and the other parts. I have to go east in a few days to pick up a loader pucket in Little Rock....
give me a call at 405-641-8547
agengineer
|
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |