This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


AC 400 and 500 loaders?
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
Tracy Martin TN View Drop Down
Orange Level Access
Orange Level Access
Avatar

Joined: 11 Sep 2009
Location: Gallatin,TN
Points: 10769 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Tracy Martin TN Quote  Post ReplyReply Direct Link To This Post Topic: AC 400 and 500 loaders?
    Posted: 17 hours 14 minutes ago at 9:54pm
Has anyone ever made a bracket to pin cylinder rods and loader arms to, that mimics the loader bucket bracket with hook and pin to hold loader bucket? I want to remove bucket when not using it, but be able to attach it easily. Any help appreciated. Tracy
No greater gift than healthy grandkids!
Back to Top
Sponsored Links


Back to Top
DanWi View Drop Down
Orange Level Access
Orange Level Access
Avatar

Joined: 18 Sep 2009
Location: wttn
Points: 1924 		Post Options Post Options   Thanks (0) Thanks(0)   Quote DanWi Quote  Post ReplyReply Direct Link To This Post Posted: 16 hours 28 minutes ago at 10:40pm
I made a set for my Dual loader on my 200. They move the bucket about 6 inches forward. If I did it again I think I could get a little closer. I made them to switch between the bucket and bale forks. The top hole is cut open to the top like a quick hitch and I just leave the pins in the bucket and hook it and pick it up then put the bottom pin in to secure it. I welded some stop in so the pins always line up. I made them out of 1/2 inch plate. I have hooked a chain in them to pick things uand even with the bucket off you can push things with them on if you need to.

Edited by DanWi - 16 hours 24 minutes ago at 10:44pm
Back to Top
Tracy Martin TN View Drop Down
Orange Level Access
Orange Level Access
Avatar

Joined: 11 Sep 2009
Location: Gallatin,TN
Points: 10769 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Tracy Martin TN Quote  Post ReplyReply Direct Link To This Post Posted: 15 hours 39 minutes ago at 11:29pm
Dan, that sounds like what i need.  Sent you a PM. Thanks, Tracy
No greater gift than healthy grandkids!
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.078 seconds.


Help Support the
Unofficial Allis Forum