This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Construction and other equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


allis h4 upper roller
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
pinball View Drop Down
Orange Level Access
Orange Level Access


Joined: 28 May 2014
Location: missouriu
Points: 6351 		Post Options Post Options   Thanks (0) Thanks(0)   Quote pinball Quote  Post ReplyReply Direct Link To This Post Topic: allis h4 upper roller
    Posted: 23 Jun 2014 at 5:53pm
bought an allis h4 while back . it is really egg shaped. almost just has three sides. Pulled it off and the support arm is very nice. it still had oil in it. Just wondered what causes it to get shaped like that. thanks norm
Back to Top
Sponsored Links


Back to Top
DiyDave View Drop Down
Orange Level Access
Orange Level Access
Avatar

Joined: 11 Sep 2009
Location: Gambrills, MD
Points: 53737 		Post Options Post Options   Thanks (0) Thanks(0)   Quote DiyDave Quote  Post ReplyReply Direct Link To This Post Posted: 23 Jun 2014 at 6:36pm
Bearing froze up, and track slid across rather than it turning, would be my guess...
Back to Top
DonBC View Drop Down
Orange Level Access
Orange Level Access
Avatar

Joined: 12 Sep 2009
Location: Courtenay, BC,
Points: 941 		Post Options Post Options   Thanks (0) Thanks(0)   Quote DonBC Quote  Post ReplyReply Direct Link To This Post Posted: 24 Jun 2014 at 10:16am
If was located in an area that had winter I would say that it was run a lot with the roller packed up with ice and snow. Possibly run a lot with the rollers jambed up with mud?
Jack of all trades, master of none
Back to Top
Andrew_D View Drop Down
Silver Level
Silver Level


Joined: 28 May 2013
Location: Newdale,MB,Can
Points: 148 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Andrew_D Quote  Post ReplyReply Direct Link To This Post Posted: 24 Jun 2014 at 11:43am
Mud was going to be my guess. Although, if it is egg/triangle shaped, that's quite a bit of work without the roller turning to cause that much wear!

Andrew



Edited by Andrew_D - 24 Jun 2014 at 11:43am
Back to Top
pinball View Drop Down
Orange Level Access
Orange Level Access


Joined: 28 May 2014
Location: missouriu
Points: 6351 		Post Options Post Options   Thanks (0) Thanks(0)   Quote pinball Quote  Post ReplyReply Direct Link To This Post Posted: 24 Jun 2014 at 4:30pm
I think your mud/ice might be correct. it came from Minnesota. since the roller was free then I would believe it got packed with ice/mud. the track has about 4 inches of slop in it. . thanks norm
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 1.023 seconds.


Help Support the
Unofficial Allis Forum