farmal 450 pto slipping

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   First off sorry for the wrong forum, but I get more help here than YT. I have a 450 and the PTO needs adjusted It slips when engaging our baler. Once running it never slips. There is a load band and a brake band How do you tighten the load band. Where are the tightening bolts? Once again sorry for the wrong color.

	This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
	The Forum	Parts and Services	Unofficial Allis Store	Tractor Shows	Serial Numbers	History

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
craigreavley Members Profile Send Private Message Find Members Posts Add to Buddy List Silver Level Joined: 09 Sep 2010 Location: illinois Points: 119	Post Options Post Reply Quote craigreavley Report Post Thanks(0) Quote Reply Topic: farmal 450 pto slipping Posted: 09 Jul 2011 at 8:55am
	First off sorry for the wrong forum, but I get more help here than YT. I have a 450 and the PTO needs adjusted It slips when engaging our baler. Once running it never slips. There is a load band and a brake band How do you tighten the load band. Where are the tightening bolts? Once again sorry for the wrong color.

Sponsored Links

cougar766 Members Profile Send Private Message Find Members Posts Add to Buddy List Silver Level Joined: 15 Sep 2009 Location: Amo, Indiana Points: 150	Post Options Post Reply Quote cougar766 Report Post Thanks(0) Quote Reply Posted: 09 Jul 2011 at 10:26am
	sorry my scanner is out of order but I'll type what the manual says and try to describe the pictures. #1: loosen the lock nuts & back out the anchor bolts 4 turns. #2 hold IPTO op lever so punch mark on pawl aligns with punch mark on quadrant. #3 turn anchor in until reasonably tight, finger tighten lock nuts, move handle back n forth several times. #4 back out anchor bolts 1 turn n lock lock nuts # 5use a 5/16 rod 7-8 in long to freely turn shaft with punch mark in alignment (if it turns easy any other time the bolts are adj. uneven and need to be redone n rechecked) replace cover & PTO shield ( the described cover is on the right top side of PTO beside the lever pivot) hope this helps David

Coke-in-MN Members Profile Send Private Message Find Members Posts Add to Buddy List Orange Level Access Joined: 12 Sep 2009 Location: Afton MN Points: 41980	Post Options Post Reply Quote Coke-in-MN Report Post Thanks(0) Quote Reply Posted: 09 Jul 2011 at 11:01am
	Have trouble with mine slipping under load . Have adjusted bands but still seems to slip. Can pull up on lever and it will help but can't seem to get levr to adjust tight enough to keep slippage from being a problem, as now lever is almost two hands to raise.
	Life lesson: If you’re being chased by a lion, you’re on a horse, to the left of you is a giraffe and on the right is a unicorn, what do you do? You stop drinking and get off the carousel.