D10 manifold stud question

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   I recently ordered a manifold kit for my d10, which requires 6 long and 2 short studs.

But the studs turned out to all be 1/2” too long.

So, I checked AGCO books and I’m going to order 6 #206987 individually. I know these will work, as they should be roughly 2 1/2 “ long.

But what of the two shorter / lower studs? My manifold just had two bolts/capscrews and not actual studs. Is this correct/original?

AGCO Books diagram is a little confusing. They do depict two different studs, but the second stud pictured has a part # that references the two washers that are used on the studs that go through the “half holes” on the manifold. 

If the two capscrews are correct, it doesn’t look like they mention them either.

	This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
	The Forum	Parts and Services	Unofficial Allis Store	Tractor Shows	Serial Numbers	History

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
JayD-17(NY) Members Profile Send Private Message Find Members Posts Add to Buddy List Orange Level Joined: 11 Sep 2009 Location: New York Points: 579	Post Options Post Reply Quote JayD-17(NY) Report Post Thanks(0) Quote Reply Topic: D10 manifold stud question Posted: 8 hours 49 minutes ago at 5:27pm
	I recently ordered a manifold kit for my d10, which requires 6 long and 2 short studs. But the studs turned out to all be 1/2” too long. So, I checked AGCO books and I’m going to order 6 #206987 individually. I know these will work, as they should be roughly 2 1/2 “ long. But what of the two shorter / lower studs? My manifold just had two bolts/capscrews and not actual studs. Is this correct/original? AGCO Books diagram is a little confusing. They do depict two different studs, but the second stud pictured has a part # that references the two washers that are used on the studs that go through the “half holes” on the manifold. If the two capscrews are correct, it doesn’t look like they mention them either.

Sponsored Links

WF owner Members Profile Send Private Message Find Members Posts Add to Buddy List Orange Level Joined: 12 May 2013 Location: Bombay NY Points: 5054	Post Options Post Reply Quote WF owner Report Post Thanks(0) Quote Reply Posted: 6 hours 59 minutes ago at 7:17pm
	My D-10 Series 3 appears to have 6 studs. They look to all be the same length, but some may protrude further into the block than others. I have two other D-10's that are in my warehouse down the street. I will check them tomorrow, but I think these (in the picture) are original. EDIT: The bottom ones are definitely capscrews (3/8" is my guess). I am quite sure they are original because the orange paint looks unmolested. Edited by WF owner - 6 hours 47 minutes ago at 7:29pm