This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


WD/WD45 Question

 Post Reply Post Reply
Author
Message
Dennis J OPKs View Drop Down
Orange Level
Orange Level


Joined: 12 Sep 2009
Location: Overland Park,
Points: 533
Post Options Post Options   Thanks (0) Thanks(0)   Quote Dennis J OPKs Quote  Post ReplyReply Direct Link To This Post Topic: WD/WD45 Question
    Posted: 1 hour 54 minutes ago at 8:52am
I've only seen this on 2 tractors.  One was mine & the other was at a show in Ottawa KS.  The right rear corner of the platform was cut out-about a 5- or 6-inch section, smooth cut, not a torch job.  I don't have a photo.  I immediately replaced the platform, and the old one went to scrap.  This was obviously done to gain clearance for some rear implement, mounted or pull type.  That's under the seat so it couldn't have been very long.  Both of these sightings were in KS which means nothing.  So, this question is thrown out there for your answer.  Someone must know.  Thanks.
Back to Top
Sponsored Links


Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.070 seconds.


Help Support the
Unofficial Allis Forum