D-14 power steering

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   Not working - oil level is up to top of sector gear but no power assist. I can hear the pump trying to help when wheel is turned but no power assist. What could be wrong?

	This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
	The Forum	Parts and Services	Unofficial Allis Store	Tractor Shows	Serial Numbers	History

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
only AC orange Members Profile Send Private Message Find Members Posts Add to Buddy List Orange Level Access Joined: 06 Dec 2014 Location: Eastern Indiana Points: 530	Post Options Post Reply Quote only AC orange Report Post Thanks(0) Quote Reply Topic: D-14 power steering Posted: Yesterday at 4:40pm
	Not working - oil level is up to top of sector gear but no power assist. I can hear the pump trying to help when wheel is turned but no power assist. What could be wrong?

Sponsored Links

AC720Man Members Profile Send Private Message Find Members Posts Add to Buddy List Orange Level Joined: 10 Oct 2016 Location: Shenandoah, Va Points: 5234	Post Options Post Reply Quote AC720Man Report Post Thanks(0) Quote Reply Posted: 1 hour 38 minutes ago at 4:50pm
	Did this happen all the sudden or get weak over time? What oil are you running in it? I had 2 issue on mine when I put the power steering front end on it. First thing was the drive pin was missing on the driveshaft that drives the gears. Previous owner must have had an issue and removed the pin to prevent the gears from running due to no oil in the pump. I figured that out after I found the pick up tube clogged completely with debris/dirt. Pulled the tube back off and cleaned it out with parts washer and then blew it out with my air compressor. Installed the pin, added oil and she has worked perfectly since. Let me add I had disassembled the front support to inspect all bearings and do a though cleaning while I had it apart. This was a donor front support and I had no idea of its history. I ended up converting my front support by moving the necessary parts over to it. The parts tractor was a non runner and the sector bearings were bad, mine were in excellent condition. That was actually a fun project and I learned a lot from it. Edited by AC720Man - 1 hour 31 minutes ago at 4:57pm
	1968 B-208, 1976 720 (2 of them)Danco brush hog, single bottom plow,52" snow thrower, belly mower,rear tine tiller, rear blade, front blade, 57"sickle bar,1983 917 hydro, 1968 7hp sno-bee, 1968 190XTD