| Author |
 Topic Search  Topic Options
|
Dick L 
Orange Level
Joined: 12 Sep 2009
Location: Edon Ohio
Points: 5087
|
 Post Options
 Thanks(0)
 Quote  Reply
 Topic: Barn Door Needs Adjusting
Posted: 08 Dec 2021 at 1:11pm |
Not sure I am up to it this winter
|
 |
|
Sponsored Links
|
|
|
DiyDave
Orange Level Access
Joined: 11 Sep 2009
Location: Gambrills, MD
Points: 53248
|
Post Options
Thanks(0)
Quote Reply
Posted: 08 Dec 2021 at 6:07pm |
You might be able to take a crow bar and raise it up enough to take the weight off of the affected roller. Unfortunately most all of them rollers require some ladder work, to adjust... Good Luck! 
|
|
Source: Babylon Bee. Sponsored by BRAWNDO, its got what you need!
|
|
Dick L
Orange Level
Joined: 12 Sep 2009
Location: Edon Ohio
Points: 5087
|
Post Options
Thanks(0)
Quote Reply
Posted: 08 Dec 2021 at 6:35pm |
 DiyDave wrote:
You might be able to take a crow bar and raise it up enough to take the weight off of the affected roller. Unfortunately most all of them rollers require some ladder work, to adjust... Good Luck! |
I took a video and looked it over from my chair and I could see the lock nut on the hanger bolt. I'll probly set up the scaffolding.
|
|
Ted J
Orange Level
Joined: 05 Jul 2010
Location: La Crosse, WI
Points: 18923
|
Post Options
Thanks(0)
Quote Reply
Posted: 09 Dec 2021 at 1:03am |
|
Haven't you got some high school kids that live close by who would like to do you a favor? It sure wouldn't take them long. I'd come do it if I was closer!
|
|
"Allis-Express"
19?? WC / 1941 C / 1952 CA / 1956 WD45 / 1957 WD45 / 1958 D-17
|
|
DiyDave
Orange Level Access
Joined: 11 Sep 2009
Location: Gambrills, MD
Points: 53248
|
Post Options
Thanks(0)
Quote Reply
Posted: 09 Dec 2021 at 4:36am |
If I remember right, there is a flat spot, on the threads of the hanger, and a nut below the roller wheels, tighten the nut while holding the bolt... Don't remember the sizes, unfortunately...
|
|
Source: Babylon Bee. Sponsored by BRAWNDO, its got what you need!
|
|
Dick L
Orange Level
Joined: 12 Sep 2009
Location: Edon Ohio
Points: 5087
|
Post Options
Thanks(0)
Quote Reply
Posted: 09 Dec 2021 at 6:34am |
DiyDave wrote:
If I remember right, there is a flat spot, on the threads of the hanger, and a nut below the roller wheels, tighten the nut while holding the bolt... Don't remember the sizes, unfortunately... |
That is the way it works. I have it shut and with enough effort can slide it open and closed. After I put more thought into it I think I can pry the door up and put a block under it to where I can adjust it. I kept it closed all last winter. Mainly because I had lumber stacked in front as well as the saw.
|
|
