This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity. | ||||||
The Forum | Parts and Services | Unofficial Allis Store | Tractor Shows | Serial Numbers | History |
2007 Silverado no start |
Post Reply |
Author | |
bobkyllo
Orange Level Joined: 14 Sep 2009 Location: minnesota Points: 1545 |
Post Options
Thanks(0)
Posted: 26 Aug 2021 at 10:01pm |
I had to do a service call today. Customer said vehicle wouldnt start.
Got to the customer and found battery junk. Lucky I brought that with. But further investigation showed some very strange goings on. I found the radio and dash are delayed when you turn the key to run. Almost like the truck is thinking before it turns it on. Second is the windows do not work at all. Third is the park reverse nuetral indicator does not have a line under the current selection and the park shift lock is not working. It seems to me I've stumbled upon this in the past but for the life of me I can't remember where I read up on it. Am I looking at a transmission computer, key switch, etc. I told.the customer I need to study up on this and come back. They were fine with that. What path do you guys suggest I take. |
|
Sponsored Links | |
jaybmiller
Orange Level Access Joined: 12 Sep 2009 Location: Greensville,Ont Points: 22399 |
Post Options
Thanks(0)
|
1 ) corroded +12 from starter to truck fuse panel ? if the battery goes to starter THEN up to fusel panel (well chevvies used to...), a badly corroded 'feed' wire would/could 'delay' the voltage getting to the switch and things. if it started up fine, that'd mean the battery to starter wire is ok. 2) the other possibilty is the actual ignition switch.worn out..very little copper left to get electrons where they're needed.Probably used a zillion times, EOL ( End Of Life) My gut says #2
|
|
3 D-14s,A-C forklift, B-112
Kubota BX23S lil' TOOT( The Other Orange Tractor) Never burn your bridges, unless you can walk on water |
|
fixer1958
Orange Level Joined: 13 Feb 2010 Location: kansas Points: 2434 |
Post Options
Thanks(0)
|
Can you pull up any scanner data to see if you communicating with all the modules?
PCM BCM instrument cluster etc.
|
|
dee_veloper
Orange Level Joined: 12 Apr 2021 Location: USA Points: 1168 |
Post Options
Thanks(0)
|
If it had a dead battery, the computer probably needed to reset itself. May take a few drive cycles to get things back in order. The park/neutral switch may be going out. A separate issue.
As for the windows, that's may also be a separate issue; could be any number of things. To get to the bottom of all this, I agree with the need to plug in a good scanner and see what is/isn't happening. |
|
Don't confuse my personality with my attitude.
My personality is who I am. My attitude depends on who you are. |
|
HudCo
Orange Level Joined: 29 Jan 2013 Location: Plymouth Utah Points: 3519 |
Post Options
Thanks(0)
|
the park lock in that one its probley a 2500 ? has a part inside that breaks ,pull the trans pan not a hard fix, and do the gear shifter switch at the same time
|
|
JoeO(CMO)
Orange Level Joined: 11 Sep 2009 Location: Cent Missouri Points: 2694 |
Post Options
Thanks(0)
|
I had a 2004 2500HD that acted very close to this, they went through the electrical to a common point of the ignition switch,
noted fails I can remember- A/C check engine power windows plus others but bottom line was ignition switch fix. I've slept since then
Edited by JoeO(CMO) - 28 Aug 2021 at 7:14am |
|
bobkyllo
Orange Level Joined: 14 Sep 2009 Location: minnesota Points: 1545 |
Post Options
Thanks(0)
|
Thank you guys for your thoughts. This is the new body style Chevy 1500.
So it's a bit more complex then the 03-06 classic style but not too much. I'll have to get it down to the shop to really dig into it. Someone mentioned it will need a few drive cycles. It won't even crank let alone drive. I did forget to mention earlier, I noticed there was no indication telling me what gear I was in. Well I forgot to tell you guys that the park lock doesn't work either. I frankly think this vehicle is thinking it's in gear keeping me from starting it. Who's in charge of gear selection? Is there a range switch or is it all done through the transmission computer? |
|
fixer1958
Orange Level Joined: 13 Feb 2010 Location: kansas Points: 2434 |
Post Options
Thanks(0)
|
BCM
Do the brake lights work? Is the pass lock kicking in (anti theft light) with the key on? Your going to have to watch the scanner data to see what's working and what isn't. My opinion.
|
|
Brian Jasper co. Ia
Orange Level Joined: 11 Sep 2009 Location: Prairie City Ia Points: 10508 |
Post Options
Thanks(0)
|
With no PRNDL, almost certainly the TCM is off line. It will not crank until the TCM reports either Park or Neutral. With other things not working, there’s a chance that the high speed network is down. Disconnect the battery and put your ohmmeter across pins 6 and 14. Should read 60 ohms. 120 ohms means there is a break on one leg, infinite resistance both legs are open.
|
|
"Any man who thinks he can be happy and prosperous by letting the government take care of him better take a closer look at the American Indian." Henry Ford
|
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |