This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


8050 pto hdraulic leak
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
DougG View Drop Down
Orange Level
Orange Level


Joined: 20 Sep 2009
Location: Mo
Points: 8367 		Post Options Post Options   Thanks (0) Thanks(0)   Quote DougG Quote  Post ReplyReply Direct Link To This Post Topic: 8050 pto hdraulic leak
    Posted: 13 Jun 2020 at 2:34pm
Looking at an Allis 8050 and it has a pretty good hydraulic leak dripping from the pto shaft, how big of job is this to change the seal? 
Back to Top
Sponsored Links


Back to Top
LB0442 View Drop Down
Orange Level
Orange Level
Avatar

Joined: 27 Dec 2014
Location: Boise ID
Points: 767 		Post Options Post Options   Thanks (0) Thanks(0)   Quote LB0442 Quote  Post ReplyReply Direct Link To This Post Posted: 13 Jun 2020 at 8:36pm
If it has just the 1000 PTO then you can get the seal from the back.  If it has 540/1000 you have to drain rear end oil, drop that rear cover/plate and you will see both gears and a large nut.  Remove the wire and pin, back off nut then you can remove shaft to replace seal.  Mark where the old nut was as there is a slight preload on the bearings in there.
Back to Top
DougG View Drop Down
Orange Level
Orange Level


Joined: 20 Sep 2009
Location: Mo
Points: 8367 		Post Options Post Options   Thanks (0) Thanks(0)   Quote DougG Quote  Post ReplyReply Direct Link To This Post Posted: 13 Jun 2020 at 9:19pm
Thanks for the great info..  
Back to Top
MACK View Drop Down
Orange Level
Orange Level


Joined: 17 Nov 2009
Points: 7664 		Post Options Post Options   Thanks (0) Thanks(0)   Quote MACK Quote  Post ReplyReply Direct Link To This Post Posted: 13 Jun 2020 at 9:31pm
After you remove nut, use slide hammer to remove inner shaft. Then remove bolts behind outer flange. Then pry shaft assembly out, catching the two gears and thrust bearings.        MACK
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.080 seconds.


Help Support the
Unofficial Allis Forum