This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity. | ||||||
The Forum | Parts and Services | Unofficial Allis Store | Tractor Shows | Serial Numbers | History |
190XT rear ends |
Post Reply |
Author | |
youngorange2000
Silver Level Joined: 27 Mar 2019 Location: eastcentral MN Points: 308 |
Post Options
Thanks(0)
Posted: 30 Mar 2020 at 6:59pm |
I know there is the early small axle 190 and 190xt prior serial #9001 and that its internal parts are non inter changeable with the later ones I also know that they did some improvements in the series 3 rear ends. What would I need to look out for when swapping a SN#13,xxx rearend onto a SN#11,000 tractor from the back of the torque tube back (trans,bull gears,pinion and ring gear) into the my tractor has a bad bull gear,bad output shaft bearings,axle bearing and seals,ring and pinion,inputshaft, and 3erd gear is chipped in a dozen spots. My thoughts are take my good PD and put it on a good rearend, some new gaskets and seals bolt it in and let'er run. what would/should I watch out for?
|
|
Sponsored Links | |
MACK
Orange Level Joined: 17 Nov 2009 Points: 7664 |
Post Options
Thanks(0)
|
Should be a go. MACK
|
|
youngorange2000
Silver Level Joined: 27 Mar 2019 Location: eastcentral MN Points: 308 |
Post Options
Thanks(0)
|
ordered the gaskets today we will find out very soon
|
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |