| Author |
 Topic Search  Topic Options
|
Dana Miller 
Bronze Level
Joined: 11 Apr 2018
Location: macks creek
Points: 5
|
 Post Options
 Thanks(0)
 Quote  Reply
 Topic: Allis D-14 wiring problem
Posted: 11 Apr 2018 at 10:22pm |
|
I am putting A new ignition switch {2-wire} in my D-14.It starts,runs, but when I turn the key off it keeps running.Has been converted to 12 volt.I am not sure I put the yellow wire in the right place,also has A start button.I just need to know where this yellow wire goes...I forgot! Thank you!
|
 |
|
Sponsored Links
|
|
|
DougS
Orange Level
Joined: 03 Nov 2011
Location: Iowa
Points: 2490
|
Post Options
Thanks(0)
Quote Reply
Posted: 12 Apr 2018 at 4:20am |
|
Does it have an alternator? If so you need a diode or lamp on the exciter line. You can also change the 2-wire ignition switch to a key switch and use the ACC position for the exciter line.
|
|
jaybmiller
Orange Level Access
Joined: 12 Sep 2009
Location: Greensville,Ont
Points: 24697
|
Post Options
Thanks(0)
Quote Reply
Posted: 12 Apr 2018 at 5:55am |
|
Hmm.. yellow is the coil feed, through the ballast resistor. Since it was 'converted to 12V' , I'm with DougS and thinking it has an alternator on it now.
If so, the alternator wire is attached to the ignition switch on the coil side. Removing the alternator wire and putting it onto the other terminal of the ignition switch( the 'feed' side) will solve the problem.
I'm basing this on fig 184 of the I&T book, wiring for D-14 tractor.
What's interesting to me as none of the 3 wiring diagrams show a ballast resistor, and all 4 of the D-14s I'v had have them....
|
|
3 D-14s,A-C forklift, B-112
Kubota BX23S lil' TOOT( The Other Orange Tractor)
Never burn your bridges, unless you can walk on water
|
|
Dana Miller
Bronze Level
Joined: 11 Apr 2018
Location: macks creek
Points: 5
|
Post Options
Thanks(0)
Quote Reply
Posted: 12 Apr 2018 at 11:12am |
|
has alternator,and key switch,also has push start button.wouldnt shut off when I put key in off position.thank you for responding.
|
|
Dana Miller
Bronze Level
Joined: 11 Apr 2018
Location: macks creek
Points: 5
|
Post Options
Thanks(0)
Quote Reply
Posted: 12 Apr 2018 at 11:27am |
|
headed out to do this.hopefully this ole farm girl gets it right. thanks again Dana
|
|
DSeries4
Orange Level
Joined: 12 Sep 2009
Location: Ontario, Canada
Points: 7505
|
Post Options
Thanks(0)
Quote Reply
Posted: 12 Apr 2018 at 6:51pm |
|
Did you get a wiring diagram with your kit? Not all kits will use a yellow wire going to the same place. When in doubt, look over the wiring diagram and match up your wires.
|
|
'49 G, '54 WD45, '55 CA, '56 WD45D, '57 WD45, '58 D14, '59 D14, '60 D14, '63 D15D, '66 D15II, '66 D21II, '67 D17IV, '67 D17IVD, '67 190XTD, '73 620, '76 185, '77 175, '84 8030, '85 6080
|
|
Dana Miller
Bronze Level
Joined: 11 Apr 2018
Location: macks creek
Points: 5
|
Post Options
Thanks(0)
Quote Reply
Posted: 12 Apr 2018 at 9:10pm |
|
no schematic was sent, but I followed what Mr.Miller said.Decided to re-wire all the hard old wires,and added A dash lamp and headlight wires today.Got it all done. Ran out of time for today to start it.Tomorrow I will run it and see.Thank you Dana Miller
|
|
