This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


Another 6080? PTO shaft
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
chuck View Drop Down
Silver Level
Silver Level
Avatar

Joined: 29 Sep 2009
Location: wisconsin
Points: 110 		Post Options Post Options   Thanks (0) Thanks(0)   Quote chuck Quote  Post ReplyReply Direct Link To This Post Topic: Another 6080? PTO shaft
    Posted: 08 Apr 2018 at 12:27am
Where the PTO shaft comes out of the main transmission shaft and in to the clutch, is there a seal in the back of the hollow shaft that the PTO shaft goes through, and if so how do you get to it, trying to seal up all the leaks while its apart. When I split it the clutch was soaked with oil.
Back to Top
Sponsored Links


Back to Top
LB0442 View Drop Down
Orange Level
Orange Level
Avatar

Joined: 27 Dec 2014
Location: Boise ID
Points: 767 		Post Options Post Options   Thanks (0) Thanks(0)   Quote LB0442 Quote  Post ReplyReply Direct Link To This Post Posted: 08 Apr 2018 at 9:21am
It is the trans front seal, had the exact same issue.  Clutch was soaked in oil.  The tough part was the O ring on the front bearing retainer did not want to stay in the groove when putting it back in.  Not a drop of oil out of it since then.  Clutch works great.
Back to Top
chuck View Drop Down
Silver Level
Silver Level
Avatar

Joined: 29 Sep 2009
Location: wisconsin
Points: 110 		Post Options Post Options   Thanks (0) Thanks(0)   Quote chuck Quote  Post ReplyReply Direct Link To This Post Posted: 08 Apr 2018 at 9:41am
I got the new seal and oring for front retainer, just thought I would try to replace seal for the PTO shaft, it must be on back side of main shaft, just not sure how to get at it. Mine had about a half inch of oil in the back part of bell housing there. Thanks for the pic
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.074 seconds.


Help Support the
Unofficial Allis Forum