![]() |
This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity. | |||||
The Forum | Parts and Services | Unofficial Allis Store | Tractor Shows | Serial Numbers | History |
Delco SI alternator |
Post Reply ![]() |
Author | |
allisbred ![]() Orange Level Access ![]() Joined: 28 Mar 2015 Location: Hanover Pa Points: 1011 |
![]() ![]() ![]() ![]() ![]() Posted: 22 Mar 2018 at 8:06pm |
Have a tractor that sat for awhile and have to trip the relay to get the 1 wire alternator working every time the motor goes back to idle. Is the relay causing this issue or can the magnetic field be lost permently from sitting. I'm not a fan of these but, was already installed, I think they seem to draw some power when not in use.
|
|
![]() |
|
Sponsored Links | |
![]() |
|
Dakota Dave ![]() Orange Level ![]() ![]() Joined: 12 Sep 2009 Location: ND Points: 3964 |
![]() ![]() ![]() ![]() ![]() |
Delco SI alternators are internally regulated and don't have a relay. If you have a relay on one it's wired wrong.
|
|
![]() |
|
Coke-in-MN ![]() Orange Level Access ![]() Joined: 12 Sep 2009 Location: Afton MN Points: 41819 |
![]() ![]() ![]() ![]() ![]() |
The 10 SI needs a higher RPM to excite and once output is established it will stay charging or regulating internally - no magnetism involved until electric flows - as not like a generator with residual or self exciting .
If it's drawing power when off - bad diode in diode trio - replace that . look on back and there should be a U shaped hole in back casting - just inside a bit is a tab - if you take a small screwdriver and touch case and that tab it should give you full output from alternator - if not internal regulator could also be bad Edited by Coke-in-MN - 22 Mar 2018 at 8:26pm |
|
Faith isn't a jump in the dark. It is a walk in the light. Faith is not guessing; it is knowing something.
"Challenges are what make life interesting; overcoming them is what makes life meaningful." |
|
![]() |
|
allisbred ![]() Orange Level Access ![]() Joined: 28 Mar 2015 Location: Hanover Pa Points: 1011 |
![]() ![]() ![]() ![]() ![]() |
No external relay, you would be correct, it is the regulator that I'm thinking about in the alternator. This tractor is new to me and has not been working yet. Just trying to figure what I need to fix first.
|
|
![]() |
|
allisbred ![]() Orange Level Access ![]() Joined: 28 Mar 2015 Location: Hanover Pa Points: 1011 |
![]() ![]() ![]() ![]() ![]() |
Ok-- thank you. Kevin
|
|
![]() |
|
Bill_MN ![]() Orange Level ![]() ![]() Joined: 12 Sep 2009 Location: Sioux Falls, SD Points: 1466 |
![]() ![]() ![]() ![]() ![]() |
Sounds like alternator replacement is in order. One wire alternators do not belong on a tractor, use a three-wire. There's nothing wrong with the Delco if it's installed/working properly...
|
|
1951 WD #78283, 1918 Case 28x50 Thresher #76738, Case Centennial B 2x16 Plow
|
|
![]() |
|
wfmurray ![]() Orange Level ![]() Joined: 13 Sep 2009 Location: Bostic NC Points: 1225 |
![]() ![]() ![]() ![]() ![]() |
On my B i put an aternator on . To get it to exciet i put a nor open switch on .Crank engine and pull switch to on and it starts charging.Turn switch loose and it still charges untll engine stops .In nor open it will not run bat down when not in use . Works good for me.
|
|
![]() |
|
jaybmiller ![]() Orange Level Access ![]() Joined: 12 Sep 2009 Location: Greensville,Ont Points: 24338 |
![]() ![]() ![]() ![]() ![]() |
you could just put a smaller diamter pulley on the alternator. AIn't no way a tractors going to rev faster than a car !
|
|
3 D-14s,A-C forklift, B-112
Kubota BX23S lil' TOOT( The Other Orange Tractor) Never burn your bridges, unless you can walk on water |
|
![]() |
Post Reply ![]() |
|
Tweet
|
Forum Jump | Forum Permissions ![]() You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |