![]() |
This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity. | |||||
| The Forum | Parts and Services | Unofficial Allis Store | Tractor Shows | Serial Numbers | History | |
190 |
Post Reply
|
| Author | |
showcattle75
Silver Level
Joined: 29 Oct 2013 Location: Iowa Points: 72 |
Post Options
Thanks(0)
Quote Reply
Topic: 190Posted: 17 May 2017 at 4:48pm |
|
Final drive and pd. I need to change the oil in my final drive but my manual dosent tell me where to refill. Also when my pd is in the natural position the tractor still moves forward I can hold it with the breaks is there something I need to look at ?
|
|
![]() |
|
| Sponsored Links | |
![]() |
|
MACK
Orange Level
Joined: 17 Nov 2009 Points: 7664 |
Post Options
Thanks(0)
Quote Reply
Posted: 17 May 2017 at 9:32pm |
|
Pump it in the check plug holes on side of housing just below axel level.
Should set with hot oil. Will want to pull with cold oil. MACK |
|
![]() |
|
showcattle75
Silver Level
Joined: 29 Oct 2013 Location: Iowa Points: 72 |
Post Options
Thanks(0)
Quote Reply
Posted: 23 May 2017 at 11:16am |
|
I pulled plugs on final drive. If you stand behind the tractor the final drive on the right hadbout what it sould be in there. When I pulled the plug for the left side all the fluid in the trans mission came out amd I could here a hissing noise from about the left final drive. I thought the final drives were seperate from transmisson or is this normal ?
|
|
![]() |
|
CAL(KS)
Orange Level
Joined: 18 Sep 2009 Location: Chapman, KS Points: 3804 |
Post Options
Thanks(0)
Quote Reply
Posted: 23 May 2017 at 11:39am |
|
finals are separate. hissing noise might be vent on transmission because the axle cap has come off allowing trans oil into final. you will need to pull the rear housing and reinstall cap inside. I suppose the seal could be bad on the pinion shaft as well but more likely the cap came off.
this is what it looks like inside. you can see the RH cap
![]() Edited by CAL(KS) - 23 May 2017 at 11:46am |
|
|
Me -C,U,UC,WC,WD45,190XT,TL-12,145T,HD6G,HD16,HD20
Dad- WD, D17D, D19D, RT100A, 7020, 7080,7580, 2-8550's, 2-S77, HD15 |
|
![]() |
|
showcattle75
Silver Level
Joined: 29 Oct 2013 Location: Iowa Points: 72 |
Post Options
Thanks(0)
Quote Reply
Posted: 23 May 2017 at 2:54pm |
|
Will it hurt if I fill with hytran until I split tractor ?
|
|
![]() |
|
DougG
Orange Level
Joined: 20 Sep 2009 Location: Mo Points: 8393 |
Post Options
Thanks(0)
Quote Reply
Posted: 23 May 2017 at 6:04pm |
|
It probably is just an axle cap and all you have to do is pull the rear 3 pt housing off and you,ll se it laying in there, if you don't have time for that and need it now, fill it with fluid and run it,its probably been like that for years , I bet theres some out there that the finals haven't been checked and are the same
|
|
![]() |
|
showcattle75
Silver Level
Joined: 29 Oct 2013 Location: Iowa Points: 72 |
Post Options
Thanks(0)
Quote Reply
Posted: 23 May 2017 at 7:41pm |
|
Ya itsmy grandpas tractor and he passed away awhile back just now gettting to fix it up. So idk hoe long it been since final drives were check. Should I pull pto shaft out first before removing the big cover ?
|
|
![]() |
|
DanWi
Orange Level Access
Joined: 18 Sep 2009 Location: wttn Points: 1996 |
Post Options
Thanks(0)
Quote Reply
Posted: 23 May 2017 at 8:57pm |
|
If you keep the trans full it will fill the axle and you can have an axle seal leak. Had that on ours when I put the cap back on and got all the fluids right the axle stopped leaking.
|
|
![]() |
|
showcattle75
Silver Level
Joined: 29 Oct 2013 Location: Iowa Points: 72 |
Post Options
Thanks(0)
Quote Reply
Posted: 23 May 2017 at 9:53pm |
|
It says when I put pto shaft back in I have to split tractor. Or am I reading it wrong
|
|
![]() |
|
MACK
Orange Level
Joined: 17 Nov 2009 Points: 7664 |
Post Options
Thanks(0)
Quote Reply
Posted: 24 May 2017 at 8:23am |
|
No, take PTO out and in does not require split, just drain PD along with rear end. MACK
|
|
![]() |
|
showcattle75
Silver Level
Joined: 29 Oct 2013 Location: Iowa Points: 72 |
Post Options
Thanks(0)
Quote Reply
Posted: 24 May 2017 at 4:08pm |
|
Ok I just filled both final drive so I can get hay mowed and baled. Then I plan on splitting the engine from trans to pu rear main seal in. Also 5th and 6th falls out. And in wanting to get that fixed. What all will I need or should replace while its apart
|
|
![]() |
|
CAL(KS)
Orange Level
Joined: 18 Sep 2009 Location: Chapman, KS Points: 3804 |
Post Options
Thanks(0)
Quote Reply
Posted: 24 May 2017 at 4:23pm |
|
my photo from above was from when i fixed gear jumping on my tractor. everything you see has to come apart. fix anything that needs it while your in there.
Edited by CAL(KS) - 24 May 2017 at 4:24pm |
|
|
Me -C,U,UC,WC,WD45,190XT,TL-12,145T,HD6G,HD16,HD20
Dad- WD, D17D, D19D, RT100A, 7020, 7080,7580, 2-8550's, 2-S77, HD15 |
|
![]() |
|
showcattle75
Silver Level
Joined: 29 Oct 2013 Location: Iowa Points: 72 |
Post Options
Thanks(0)
Quote Reply
Posted: 24 May 2017 at 4:25pm |
|
Ok thanks cal
|
|
![]() |
|
Post Reply
|
|
|
Tweet
|
| Forum Jump | Forum Permissions ![]() You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |