This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


200 cranking / starting trouble

 Post Reply Post Reply
Author
Message
island200 View Drop Down
Bronze Level
Bronze Level
Avatar

Joined: 06 Jul 2010
Location: P.E.I., Canada
Points: 7
Post Options Post Options   Thanks (0) Thanks(0)   Quote island200 Quote  Post ReplyReply Direct Link To This Post Topic: 200 cranking / starting trouble
    Posted: 06 Jul 2010 at 9:14pm

We have owned our 1975 200 for 30 of its 35 years.  It has always been a hard starting tractor.  Are these tractors prone to some sort of hydraulic pressure buildup, at starting, that would make the tractor hard to start?  This is a tractor that I have been extra vigilant to maintain the electrical system on since I thought this would be the logical place to start.

Back to Top
Sponsored Links


Back to Top
DrAllis View Drop Down
Orange Level Access
Orange Level Access


Joined: 12 Sep 2009
Points: 20398
Post Options Post Options   Thanks (0) Thanks(0)   Quote DrAllis Quote  Post ReplyReply Direct Link To This Post Posted: 06 Jul 2010 at 9:26pm
200's were hard starting because they were only 15 to 1 compression instead of 16 to 1 like 180-185-190-190XT. When overhauling I usually installed the higher compression stuff. Lowering injector pressures to 2800 psi from 3400 psi does help as well. Lucas brand starters were a negative versus a good old Delco-Remy starter.
Back to Top
Kcgrain View Drop Down
Orange Level
Orange Level


Joined: 24 Sep 2009
Location: Wisconsin
Points: 767
Post Options Post Options   Thanks (0) Thanks(0)   Quote Kcgrain Quote  Post ReplyReply Direct Link To This Post Posted: 06 Jul 2010 at 9:31pm
If you lowered the injection pressure form 3400 to 2800 what did you do about the timing? It would be advanced quite a bit from an early injection
Back to Top
DrAllis View Drop Down
Orange Level Access
Orange Level Access


Joined: 12 Sep 2009
Points: 20398
Post Options Post Options   Thanks (0) Thanks(0)   Quote DrAllis Quote  Post ReplyReply Direct Link To This Post Posted: 06 Jul 2010 at 9:40pm
Nothing....try it, you'll like it. Older 200's I  oft times changed to advance so the timing could be retarded down to 18 degrees BTDC instead of 24 degrees BTDC  to help starting. The injectors at 3400 psi are asking too much of a "DB" Roosa-Master pump, especially if the cranking speed is the slightest bit slow and the inj pump has much wear on it.
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.125 seconds.


Help Support the
Unofficial Allis Forum