![]() |
This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity. | |||||
The Forum | Parts and Services | Unofficial Allis Store | Tractor Shows | Serial Numbers | History |
Recommendations for tire pressure. |
Post Reply ![]() |
Author | |
Dean (West MI) ![]() Orange Level ![]() Joined: 12 Sep 2009 Location: West Michigan Points: 1277 |
![]() ![]() ![]() ![]() ![]() Posted: 19 Nov 2016 at 9:20am |
I have a B with 12.4 x 24 Firestone Field and Road tires. Tractor has rear wheel weights, 75% calcium chloride, 3 point, front wheel, wishbone and engine weights. The 3 point gets used a lot to pick up heavy loads.
What PSI would you air the rear tires to?
|
|
![]() |
|
Sponsored Links | |
![]() |
|
DSeries4 ![]() Orange Level ![]() ![]() Joined: 12 Sep 2009 Location: Ontario, Canada Points: 7449 |
![]() ![]() ![]() ![]() ![]() |
15 PSI should be good.
|
|
'49 G, '54 WD45, '55 CA, '56 WD45D, '57 WD45, '58 D14, '59 D14, '60 D14, '61 D15D, '66 D15II, '66 D21II, '67 D17IV, '67 D17IVD, '67 190XTD, '73 620, '76 185, '77 175, '84 8030, '85 6080
|
|
![]() |
|
Dakota Dave ![]() Orange Level ![]() ![]() Joined: 12 Sep 2009 Location: ND Points: 3966 |
![]() ![]() ![]() ![]() ![]() |
At 16 PSI the max load rating for the pair is 3,740 lbs. assuming you have the standard 4 ply rated tires. Id personaly go down to 12PSI. youll get much better traction if the tires flex some. My C with wheel wieghts only I run at 10 PSI.
|
|
![]() |
|
Ed (Ont) ![]() Orange Level ![]() ![]() Joined: 08 Nov 2009 Location: New Lowell, Ont Points: 1437 |
![]() ![]() ![]() ![]() ![]() |
As Dave said 12 PSI. I started at 16 and gradually worked down to 12. But anything from 12-16 should work for you. Play around a bit and see what you like. You will need a fairly good gauge to be reasonably accurate at that low pressure.
Edited by Ed (Ont) - 19 Nov 2016 at 7:24pm |
|
![]() |
Post Reply ![]() |
|
Tweet
|
Forum Jump | Forum Permissions ![]() You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |