This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


CA engine rebuild-machine work?
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
J&J View Drop Down
Bronze Level
Bronze Level


Joined: 24 Apr 2021
Location: IN
Points: 23 		Post Options Post Options   Thanks (0) Thanks(0)   Quote J&J Quote  Post ReplyReply Direct Link To This Post Topic: CA engine rebuild-machine work?
    Posted: 6 hours 49 minutes ago at 9:03pm
couple questions:

If the block needs to be decked, do I have to take material off the new sleeves as well?

I checked the crankshaft end play with a feeler gage at .041. Is this overly excessive or is this typical wear for an engine that needs an over haul? Will the new thrust bearing take care of it?

Should there be this much of a gap between the crank gear and the journal in the pic?
Back to Top
Sponsored Links


Back to Top
DrAllis View Drop Down
Orange Level Access
Orange Level Access


Joined: 12 Sep 2009
Points: 22312 		Post Options Post Options   Thanks (0) Thanks(0)   Quote DrAllis Quote  Post ReplyReply Direct Link To This Post Posted: 6 hours 41 minutes ago at 9:11pm
You typically do NOT deck those old wet-sleeve blocks. Use a good sealer around every water passage hole in the head gasket and re-torque head bolts (cold) after a couple hrs of run time. What you must do when decking is re-cut the sleeve counter bores. Too expensive for my wallet.
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.049 seconds.


Help Support the
Unofficial Allis Forum