This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


Oil pump drive pin
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
Robin Heckman View Drop Down
Bronze Level
Bronze Level
Avatar

Joined: 17 Jun 2025
Location: Pa.
Points: 2 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Robin Heckman Quote  Post ReplyReply Direct Link To This Post Topic: Oil pump drive pin
    Posted: 17 Jun 2025 at 6:26pm
Does anyone know the size pin is used on oil pump drive pin on a CA
Back to Top
Sponsored Links


Back to Top
Mikez View Drop Down
Orange Level Access
Orange Level Access
Avatar

Joined: 16 Jan 2013
Location: Usa
Points: 8740 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Mikez Quote  Post ReplyReply Direct Link To This Post Posted: 18 Jun 2025 at 7:46am
Hello welcome to the forum. I sent you an email 
Back to Top
tbran View Drop Down
Orange Level
Orange Level


Joined: 14 Sep 2009
Location: Paris Tn
Points: 3539 		Post Options Post Options   Thanks (0) Thanks(0)   Quote tbran Quote  Post ReplyReply Direct Link To This Post Posted: 19 Jun 2025 at 8:38am
If the pin is loose - you may have to repair the hole or use a slightly larger pin or spiral pin to be tight.   
When told "it's not the money,it's the principle", remember, it's always the money..
Back to Top
juniorp53 View Drop Down
Bronze Level
Bronze Level


Joined: 16 Mar 2012
Location: United States
Points: 53 		Post Options Post Options   Thanks (0) Thanks(0)   Quote juniorp53 Quote  Post ReplyReply Direct Link To This Post Posted: 19 Jun 2025 at 9:10am
5/32 x 1 1/4 dowel pin from mcmaster is what i used , no problems  used an  air hammer to peen the ends  ....i seem to recall people asking about using a roll pin,  others that may no longer be with us here on the forum advised against it  
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.070 seconds.


Help Support the
Unofficial Allis Forum