![]() |
This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity. | |||||
| The Forum | Parts and Services | Unofficial Allis Store | Tractor Shows | Serial Numbers | History | |
Final Drive Questions WD45 |
Post Reply
|
| Author | |
Jeff(WD45-SATX-TN)
Orange Level
Joined: 13 Sep 2009 Location: Sewanee, TN Points: 443 |
Post Options
Thanks(0)
Quote Reply
Topic: Final Drive Questions WD45Posted: 17 May 2010 at 9:45am |
|
I got my 45 up on blocks in the rear, removed the tires, and started the process of cleaning. Made sure the final drive pan fill plugs would move. For grins I went to pull one and see if I could sample the fluid. Well, pulled the plug and fluid ran out big time. How could the level be higher than the fill plug? Could there be so much thick grime in the bottm that the level rose? Maybe water displacing the fluid? It was a weird greenish yellow color. Panning to pull both pans, clean, check, and then seal back up. Just looking for advise. Thank Jeff |
|
|
1954 WD45 NF "Iron Tater"
|
|
![]() |
|
| Sponsored Links | |
![]() |
|
Dave(inMA)
Orange Level
Joined: 12 Sep 2009 Location: Grafton, MA Points: 2399 |
Post Options
Thanks(0)
Quote Reply
Posted: 17 May 2010 at 10:36am |
|
Jeff, that's an interesting dilemma! Could be draining into the finals from somewhere above.... brake housings? Differential?
|
|
|
WC, CA, D14, WD45
|
|
![]() |
|
Rfdeere
Orange Level
Joined: 11 Sep 2009 Location: Idaville, IN Points: 3283 |
Post Options
Thanks(0)
Quote Reply
Posted: 17 May 2010 at 2:49pm |
|
I'm guessing water ?
|
|
|
Randy Freshour,Member Indiana AC Partners,
http://www.rumelyallis.com |
|
![]() |
|
Jeff(WD45-SATX-TN)
Orange Level
Joined: 13 Sep 2009 Location: Sewanee, TN Points: 443 |
Post Options
Thanks(0)
Quote Reply
Posted: 17 May 2010 at 3:03pm |
|
Randy...
So how would water get in? Through the brake covers and down the drive axel tubes? Seems if water got in somewhere, you would see a leak in the same spot?
|
|
|
1954 WD45 NF "Iron Tater"
|
|
![]() |
|
Kevin
Silver Level
Joined: 11 Sep 2009 Points: 58 |
Post Options
Thanks(0)
Quote Reply
Posted: 17 May 2010 at 4:04pm |
|
looks like the axles seals and pinion caps are wet with oil.. water might enter here.. also check the bull gear cap make sure its sealed good..looks like to me if the differential is leaking oil it would drain underneath the tractor.could they have been filled on unlevel ground??
|
|
![]() |
|
B26240
Orange Level
Joined: 21 Nov 2009 Location: mn Points: 3866 |
Post Options
Thanks(0)
Quote Reply
Posted: 17 May 2010 at 7:03pm |
|
If you use one of those hand pumps that go in a 5gal. bucket the tube end is large enough to fill the hole. With it its possible to overfill the housing if you get the plug in fast enough.
|
|
![]() |
|
Chalmersbob
Orange Level
Joined: 11 Sep 2009 Location: Pennsylvania Points: 2122 |
Post Options
Thanks(0)
Quote Reply
Posted: 17 May 2010 at 8:50pm |
|
There is a hole in the final drive that will alow water to get in if it sits outside in the rain.
I had a wd that was the same way. I thought that the axel seals were bad, but when I dropped the pans they were full of water. Bob
|
|
![]() |
|
Post Reply
|
|
|
Tweet
|
| Forum Jump | Forum Permissions ![]() You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |