![]() |
This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity. | |||||
The Forum | Parts and Services | Unofficial Allis Store | Tractor Shows | Serial Numbers | History |
Gleaner M2 air conditioning problem |
Post Reply ![]() |
Author | |
Sandknob ![]() Orange Level ![]() ![]() Joined: 12 Sep 2009 Location: Oblong, IL Points: 2456 |
![]() ![]() ![]() ![]() ![]() Posted: 24 Sep 2015 at 7:52pm |
My M2's A/C is not working and I tracked it down to the pressure sensor closest to the grain bin. I have power to one side of it, but not the other wire (the one that goes to the compressor). Can I bypass the sensor to get it working? If not, can I take it off to replace without losing freon?
Thanks Adam |
|
![]() |
|
Sponsored Links | |
![]() |
|
tbran ![]() Orange Level ![]() Joined: 14 Sep 2009 Location: Paris Tn Points: 3526 |
![]() ![]() ![]() ![]() ![]() |
yes it unscrews and no loss will occur - unless it has been messed with. That would be either a low or high pressure switch to shut down the compressor if the psi drops below about 5 or above 400 approx. better put a set of gauges in to check
|
|
When told "it's not the money,it's the principle", remember, it's always the money..
|
|
![]() |
Post Reply ![]() |
|
Tweet
|
Forum Jump | Forum Permissions ![]() You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |