This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


8010 low pressure hydraulic line
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
PawPaw View Drop Down
Bronze Level
Bronze Level
Avatar

Joined: 21 Feb 2024
Location: NE Indiana
Points: 28 		Post Options Post Options   Thanks (0) Thanks(0)   Quote PawPaw Quote  Post ReplyReply Direct Link To This Post Topic: 8010 low pressure hydraulic line
    Posted: 31 Aug 2026 at 11:32am
Where is the best place to plumb into for return line on sprayer with hydraulic pump?
Back to Top
Sponsored Links


Back to Top
DrAllis View Drop Down
Orange Level Access
Orange Level Access


Joined: 12 Sep 2009
Points: 23482 		Post Options Post Options   Thanks (0) Thanks(0)   Quote DrAllis Quote  Post ReplyReply Direct Link To This Post Posted: 31 Aug 2026 at 11:55am
A "case-drain" line ???   There are two hoses on a sprayer pump (in and out) and this is the third line/hose??
Back to Top
PawPaw View Drop Down
Bronze Level
Bronze Level
Avatar

Joined: 21 Feb 2024
Location: NE Indiana
Points: 28 		Post Options Post Options   Thanks (0) Thanks(0)   Quote PawPaw Quote  Post ReplyReply Direct Link To This Post Posted: 31 Aug 2026 at 12:08pm
Only 2 lines to hydraulic motor pressure and return. Sorry for not being clear. Sprayer manual says best to not hook return line to remote coupler.
Back to Top
DrAllis View Drop Down
Orange Level Access
Orange Level Access


Joined: 12 Sep 2009
Points: 23482 		Post Options Post Options   Thanks (0) Thanks(0)   Quote DrAllis Quote  Post ReplyReply Direct Link To This Post Posted: 31 Aug 2026 at 12:37pm
#1. Remove lower sight glass and adapt an O-ring fitting into that hole and check your oil level using the top sight glass. #2. Plug in your second hose to the other remote valve and place that valve in FLOAT and wire it into float so it can't be bumped into HOLD.   #3. Remove the steel plate under the PTO gears and above the drawbar and drill/tap a connection into that plate with a coupler to plug your hose into.
Back to Top
PawPaw View Drop Down
Bronze Level
Bronze Level
Avatar

Joined: 21 Feb 2024
Location: NE Indiana
Points: 28 		Post Options Post Options   Thanks (0) Thanks(0)   Quote PawPaw Quote  Post ReplyReply Direct Link To This Post Posted: 31 Aug 2026 at 1:01pm
Thank you
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.070 seconds.


Help Support the
Unofficial Allis Forum