This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


7000 fuel gauge question
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
Hawk View Drop Down
Bronze Level
Bronze Level


Joined: 04 Aug 2016
Location: King George VA
Points: 10 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Hawk Quote  Post ReplyReply Direct Link To This Post Topic: 7000 fuel gauge question
    Posted: 31 May 2017 at 3:05pm
Can anyone tell me what ohm resistance the fuel gauge uses on a 7000 maroon belly. I haven't been able to find it in my service manual. I think that my sender is bad or possibly the wrong one but I don't know what the resistance is supposed to be when full and empty. Thanks for any help.
 
Chris
Back to Top
Sponsored Links


Back to Top
LB0442 View Drop Down
Orange Level
Orange Level
Avatar

Joined: 27 Dec 2014
Location: Boise ID
Points: 767 		Post Options Post Options   Thanks (0) Thanks(0)   Quote LB0442 Quote  Post ReplyReply Direct Link To This Post Posted: 01 Jun 2017 at 4:10pm
I knew I have seen it some where.  This is the 7000 manual, just basically ground it and watch gauge sweep.

Here is the page from the 6080 manual which uses the same part number gauge so the resistance readings should be right on.
Back to Top
Hawk View Drop Down
Bronze Level
Bronze Level


Joined: 04 Aug 2016
Location: King George VA
Points: 10 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Hawk Quote  Post ReplyReply Direct Link To This Post Posted: 02 Jun 2017 at 3:14pm
LB0442,

Thanks for the reply, I had checked the gauge based on the 7000 manual and all was working, but couldn't find the resistance for the sender to check it. That is exactly what I needed.

Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.061 seconds.


Help Support the
Unofficial Allis Forum