This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


WD45
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
don View Drop Down
Bronze Level
Bronze Level


Joined: 27 Mar 2011
Points: 1 		Post Options Post Options   Thanks (0) Thanks(0)   Quote don Quote  Post ReplyReply Direct Link To This Post Topic: WD45
    Posted: 27 Mar 2011 at 8:36am
can a D17 engine be put in a WD45
Back to Top
Sponsored Links


Back to Top
bubschooley View Drop Down
Bronze Level
Bronze Level


Joined: 03 Jul 2010
Location: Hicksville Ohio
Points: 18 		Post Options Post Options   Thanks (0) Thanks(0)   Quote bubschooley Quote  Post ReplyReply Direct Link To This Post Posted: 27 Mar 2011 at 8:47am
yes they can be put in a wd
Back to Top
Steve M C/IL View Drop Down
Orange Level
Orange Level


Joined: 01 Jul 2010
Location: shelbyville IL
Points: 691 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Steve M C/IL Quote  Post ReplyReply Direct Link To This Post Posted: 28 Mar 2011 at 5:34am
Use the 45 water pump and crank pulley.17's stick out too far for use in a 45
Back to Top
skipwelte View Drop Down
Orange Level
Orange Level


Joined: 29 Oct 2009
Location: Anthon, Iowa
Points: 723 		Post Options Post Options   Thanks (0) Thanks(0)   Quote skipwelte Quote  Post ReplyReply Direct Link To This Post Posted: 28 Mar 2011 at 11:54am
the crank snout on the D17 eng is longer than on a 45 eng,  the 45 crank pulley will go on but will set toward the radiator by about and 1/2 inch, so youll have to fab a spacer for your water pump pully to space it out and redrill the hole for the gernerator mouting to line everything up to the crank pulley.   The oil lines on the right side of the eng alos interfear with the steering shaft and can be rotated just a little to miss the shaft.  HTH
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.074 seconds.


Help Support the
Unofficial Allis Forum