This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


AC 170D Water Pump?
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
NC Bruce View Drop Down
Silver Level
Silver Level
Avatar

Joined: 15 Sep 2009
Location: Mill Spring, NC
Points: 223 		Post Options Post Options   Thanks (0) Thanks(0)   Quote NC Bruce Quote  Post ReplyReply Direct Link To This Post Topic: AC 170D Water Pump?
    Posted: 30 Nov 2011 at 11:38am
What all do you run into trying to remove old pulley for a new pump?
 
Anyone have (or know where to order) new Water Pump ( for DIESEL, 4.2 Perkins) with PULLEY assembly too? 
 
 Can't locate a water pump(diesel) with PULLEY already attached? 
 
AGCO  is almost $300 and you still have to press pulley, hub, & pump together?
 
What can happen if you try to press at home? ha!
thanx for any suggestions?
 
Back to Top
Sponsored Links


Back to Top
DOlson View Drop Down
Silver Level
Silver Level
Avatar

Joined: 25 Dec 2009
Location: Sarona WI
Points: 57 		Post Options Post Options   Thanks (0) Thanks(0)   Quote DOlson Quote  Post ReplyReply Direct Link To This Post Posted: 30 Nov 2011 at 1:49pm
A&I Products sells a repair kit for that pump Part # is A 3637482M91 Should be around 40 dollars,new pump is less than 60 dollars from an A&I dealer but dose not come with a new pulley
Back to Top
Tracy Martin TN View Drop Down
Orange Level Access
Orange Level Access
Avatar

Joined: 11 Sep 2009
Location: Gallatin,TN
Points: 10769 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Tracy Martin TN Quote  Post ReplyReply Direct Link To This Post Posted: 30 Nov 2011 at 3:17pm
Just make sure when installing pulley to do it correctly. Remove pulley by pulling against hub only,install by pressing against hub only, and this after supporting end of pump shaft. If pump shaft is not supported, it can damage bearing assembly. HTH Tracy Martin
Back to Top
D-17_Dave View Drop Down
Orange Level
Orange Level


Joined: 11 Sep 2009
Location: Mocksville NC
Points: 990 		Post Options Post Options   Thanks (0) Thanks(0)   Quote D-17_Dave Quote  Post ReplyReply Direct Link To This Post Posted: 30 Nov 2011 at 6:58pm
Swapping the pulley is not complicated but it does require a bearing seperator and a good press to be precise and to insure not damaging the new pump or pulley. if you want to make a road trip to Mocksville I'll be glad to change it for you. If you have a favorite machine shop close by they can probably do it in about 10 minutes.
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.078 seconds.


Help Support the
Unofficial Allis Forum