| Author |
 Topic Search  Topic Options
|
steve(ill) 
Orange Level Access
Joined: 11 Sep 2009
Location: illinois
Points: 87693
|
 Post Options
 Thanks(0)
 Quote  Reply
 Topic: plow cross shaft removal
Posted: 05 Dec 2011 at 10:04pm |
|
I have the cross shaft and vertical center plate with casting on each side setting on the floor. (3-14 span coupler plow). Has a 1/2 inch square set screw in the casting tight against the shat. I have the screw out and the castings and plate dont want to move on the shaft. Do they screw together or ??? Plate appears to be mounted between two castings and neither is moving.
|
|
Like them all, but love the "B"s.
|
 |
|
Sponsored Links
|
|
|
steve(ill)
Orange Level Access
Joined: 11 Sep 2009
Location: illinois
Points: 87693
|
Post Options
Thanks(0)
Quote Reply
Posted: 05 Dec 2011 at 10:13pm |
|
|
|
Like them all, but love the "B"s.
|
|
Gerald J.
Orange Level
Joined: 12 Sep 2009
Location: Hamilton Co, IA
Points: 5636
|
Post Options
Thanks(0)
Quote Reply
Posted: 06 Dec 2011 at 1:34am |
|
Kroil, PB Blaster, or a 50/50 mix of acetone and atf accompanied by heat and shock. Let one of the penetration brews soak a while before getting noisy. To add to the tightness besides rust, its likely the set screw pushed up a bur in the hole.
Gerald J.
|
|
TexasAllis
Silver Level
Joined: 14 Sep 2009
Location: Texas
Points: 396
|
Post Options
Thanks(0)
Quote Reply
Posted: 06 Dec 2011 at 7:07am |
 steve(ill) wrote:
I have the cross shaft and vertical center plate with casting on each side setting on the floor. (3-14 span coupler plow). Has a 1/2 inch square set screw in the casting tight against the shat. I have the screw out and the castings and plate dont want to move on the shaft. Do they screw together or ??? Plate appears to be mounted between two castings and neither is moving. |
Just like Gerald said and then put the heat to it. If you have a rosebud use it.
|
|
steve(ill)
Orange Level Access
Joined: 11 Sep 2009
Location: illinois
Points: 87693
|
Post Options
Thanks(0)
Quote Reply
Posted: 06 Dec 2011 at 5:03pm |
|
Thanks guys, i just didnt want to start beating the crap out of it , if it was screwed or pinned somehow.
|
|
Like them all, but love the "B"s.
|
|
Gerald J.
Orange Level
Joined: 12 Sep 2009
Location: Hamilton Co, IA
Points: 5636
|
Post Options
Thanks(0)
Quote Reply
Posted: 06 Dec 2011 at 6:06pm |
|
The parts pictures I looked at in my plow frames book showed only that set screw in the collar between plates, nothing for the cast flange with the three bolts through the plates. Though I could envision another set screw there in some versions. What model plow is it? That might affect the picture I should have looked at.
Gerald J.
|
|
