This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


8030 Hydraulic Filters Question
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
Michael (WI) View Drop Down
Orange Level
Orange Level


Joined: 12 Sep 2009
Location: Larrabee, WI
Points: 815 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Michael (WI) Quote  Post ReplyReply Direct Link To This Post Topic: 8030 Hydraulic Filters Question
    Posted: 28 Nov 2011 at 1:09pm
While changing the hydraulic oil and filters on the semi-new to us 8030 this weekend I think I found something wrong.  I am 90% sure that when I pulled the two filters the bypass valve was installed on the right filter instead of the left filter per both the owners manual and instruction sheet that came with the AGCO filters.  If I am correct by my fuzzy memory, what kind of damage could have been done?
Back to Top
Sponsored Links


Back to Top
MACK View Drop Down
Orange Level
Orange Level


Joined: 17 Nov 2009
Points: 7664 		Post Options Post Options   Thanks (0) Thanks(0)   Quote MACK Quote  Post ReplyReply Direct Link To This Post Posted: 28 Nov 2011 at 10:22pm
Don't think the cap from right side will open valve on left far enough to let enough oil in to work properly. If it opened enough the only problem would be if filter pluged, the pump would not get any oil.  MACK
Back to Top
Michael (WI) View Drop Down
Orange Level
Orange Level


Joined: 12 Sep 2009
Location: Larrabee, WI
Points: 815 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Michael (WI) Quote  Post ReplyReply Direct Link To This Post Posted: 29 Nov 2011 at 9:15am
Mack, I wondered about the same thing and the cap from the right side is a lot longer than the by-pass valve because of the coil spring that is on the end, so I think the valve was opened and the coil spring was just compressed a lot.  I just wish I could remeber for sure how it was when I opened it up.  I pulled the cap and valve to wash in gas and set elswhere to dry, then I wasn't possitive anymore where they came from.  Although I am pretty sure they were wrong.
Back to Top
Ron(AB) View Drop Down
Orange Level
Orange Level
Avatar

Joined: 27 Dec 2009
Location: Alberta
Points: 962 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Ron(AB) Quote  Post ReplyReply Direct Link To This Post Posted: 30 Nov 2011 at 12:33am
It won't work properly if you have them switched and you'll know as soon as you start the tractor.
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.033 seconds.


Help Support the
Unofficial Allis Forum