Unable to post

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   I have a oil leak from the PTO that appeared to be from the bottm retainer bolt hole.  I discovered that the idiot previous owner used 3 different length bolts and two of them were worn 1/4" + below the head including the bottom one. The two retainer holes the crap bolts were in (top & bottom) were out of round and the faces were ground down.  The mating housing hole for the bottm bolt was sloppy when threaded.  Of course there are high spots by the retainer bolt holes.  
There were 5 shims between the retainer and the housing and a gasket between the shims and housing but none between the retainer and the shims.

The shaft has some small dings and scratches that I [polished out. The seal looks OK but is some off-brand so I'll repkace it. 

Does anyone have a nice retainer (part # 207617)?
Should there be a gasket between the retainer and the shims? My book doesn't show one.
What's the process for the shims?
It appars that National 50135 seal would be correct. Yes?

Thanks.

	This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
	The Forum	Parts and Services	Unofficial Allis Store	Tractor Shows	Serial Numbers	History

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
Freewheeling Members Profile Send Private Message Find Members Posts Add to Buddy List Bronze Level Joined: 05 Nov 2017 Location: Wisconsin Points: 157	Post Options Post Reply Quote Freewheeling Report Post Thanks(0) Quote Reply Topic: Unable to post Posted: 10 hours 28 minutes ago at 9:57pm
	I have a oil leak from the PTO that appeared to be from the bottm retainer bolt hole. I discovered that the idiot previous owner used 3 different length bolts and two of them were worn 1/4" + below the head including the bottom one. The two retainer holes the crap bolts were in (top & bottom) were out of round and the faces were ground down. The mating housing hole for the bottm bolt was sloppy when threaded. Of course there are high spots by the retainer bolt holes. There were 5 shims between the retainer and the housing and a gasket between the shims and housing but none between the retainer and the shims. The shaft has some small dings and scratches that I [polished out. The seal looks OK but is some off-brand so I'll repkace it. Does anyone have a nice retainer (part # 207617)? Should there be a gasket between the retainer and the shims? My book doesn't show one. What's the process for the shims? It appars that National 50135 seal would be correct. Yes? Thanks.

Sponsored Links

Allis dave Members Profile Send Private Message Find Members Posts Add to Buddy List Orange Level Joined: 10 May 2012 Location: Northern IN Points: 3019	Post Options Post Reply Quote Allis dave Report Post Thanks(0) Quote Reply Posted: 1 hour 38 minutes ago at 6:47am
	What tractor are you working on?

Freewheeling Members Profile Send Private Message Find Members Posts Add to Buddy List Bronze Level Joined: 05 Nov 2017 Location: Wisconsin Points: 157	Post Options Post Reply Quote Freewheeling Report Post Thanks(0) Quote Reply Posted: 1 hour 14 minutes ago at 7:11am
	An IB.