HD11E issue
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Construction and other equipment
Forum Description: everything else with orange (or yellow) paint
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=86124
Printed Date: 30 Jun 2025 at 6:20pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: HD11E issue
Posted By: jchance
Subject: HD11E issue
Date Posted: 09 Mar 2014 at 11:37pm
hi,
i have just had an issue with my HD11E serial number 8321.
the engine works fine, however when engaging the clutch handle the dozer will not move forward or reverse.
steering left or right will not work either.
anyone have any ideas what the issue could be ?
|
Replies:
Posted By: HD6 Merv
Date Posted: 10 Mar 2014 at 2:40am
hi/lo levers probably in neutral
-------------
tits tyres and tracks
they all cost you money
|
Posted By: jchance
Date Posted: 10 Mar 2014 at 2:53am
|
i thought this as well i think it is engaged though
|
Posted By: Lazyts
Date Posted: 10 Mar 2014 at 12:27pm
Does the transmission pressure gauge show pressure? If hi-lo is engaged, transmission pressure should show with clutch engaged. If hi-lo is in neutral, you will have no trans pressure.
I don't have a manual for that tractor anymore, but fill points from memory are:
Engine oil- spring loaded cap at LH rear of engine
Hydraulic oil- square drive plug in front of radiator grille
Trans oil- cap under seat with dipstick
Bevel gear- cap under seat with dipstick
Clutch- dipstick at right rear corner of engine (reservoir is under oil pan)
Steering- plug on reservoir behind engine- fill to plug level
Final drives- square drive (1/2") plugs
Radiator- self explanatory
|
Posted By: Ray54
Date Posted: 11 Mar 2014 at 10:13am
You say engaging the clutch so I assume a manual transmission?Adjust the clutch.
Ray
|
Posted By: jchance
Date Posted: 11 Mar 2014 at 10:20am
yeah i had to adjust the clutch 4 turns
does anyone know where to buy a new clutch ?
|
Posted By: gemdozer
Date Posted: 11 Mar 2014 at 4:01pm
|
You should have a wet master cluch and make sure the oil tank level is oké
|
|