hd4 torqe convertor Gauge
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Construction and other equipment
Forum Description: everything else with orange (or yellow) paint
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=74794
Printed Date: 27 May 2024 at 6:13am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: hd4 torqe convertor Gauge
Posted By: blackbirdstud
Subject: hd4 torqe convertor Gauge
Date Posted: 07 Aug 2013 at 7:02pm
| I have a HD4 dozer, the gauge itself, the paper backing inside the gauge has gonwe bad and its sealed so I fugured I would pull the dash and replace it. but the thermal wire that leads to the torqe convertor line is crimped to the back of the gaude.. so I traced it back to the line and it looks liek either a half inch or 3/4 fitting into the line. So my question is if I buy another TEMP gauge will it have those fitting or wil I have to cut my line and crimp it to another gauge soem how?? |
Replies:
Posted By: doctorcorey
Date Posted: 07 Aug 2013 at 9:31pm
| Not sure but a replacement gauge should fit, possibly with just a pipe bushing to adapt. You can't cut the bourdon tube to the gauge, if that's what you were planning. I assume you are talking about the temp gauge. |
Posted By: doctorcorey
Date Posted: 07 Aug 2013 at 9:32pm
|
doctorcorey wrote:Posted By: Coke-in-MN
Date Posted: 08 Aug 2013 at 1:16pm
|
The gauge is a full unit, from the bulb at the end to the gauge itself . It all needs to be replaced as a unit - sensing bulb and gage itself. ------------- Faith isn't a jump in the dark. It is a walk in the light. Faith is not guessing; it is knowing something. "Challenges are what make life interesting; overcoming them is what makes life meaningful." |